Teledex IP250DVoIP manual Requirements of Part 15 FCC Rules European Requirements, 89/336/EEC

Page 3

NOTICES

REQUIREMENTS OF PART 15 - FCC RULES

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encour- aged to try to correct the interference by one or more of the following measures: a) move the telephone away from the receiver; b) consult the dealer or an experienced radio/TV technician for help. Any changes made by the user not approved by the manufacturer can void the user's authority to operate the telephone.

EUROPEAN REQUIREMENTS

This product complies with the following CE requirements:

89/336/EEC	EN 55024
EN 55022	EN 60950 (CB SCHEME)

Teledex IP250D User’s Guide SIP/MGCP	iii

Image 3

Contents VoIP Network Terminal IP250DImportant Safety Instructions 89/336/EEC Requirements of Part 15 FCC Rules European RequirementsContents Introduction to the IP250D VoIP Network Terminal Downloader Application IP250D Works Like a Telephone Introduction to the Teledex IP250D VoIP Network TerminalInstalling the IP250D Unpacking the IP250D Connecting the HandsetConnecting the IP250D to the Network Connecting a PC to the IP250DConnecting a Headset to the IP250D Arranging the IP250D on the DeskMounting the IP250D on a Wall Home Configuring the IP250DVlan Settings LAN ConfigurationMgcp Configuration LAN Interface SettingsOOB Signalling Settings Mgcp SettingsSIP Configuration Handset SettingsSIP Settings Localization Settings Codec ConfigurationSystem Configuration Security SettingsDownload Configuration Reset ConfigurationSnmp Settings Receiving a Call Using the IP250DTelephone Idle Incoming Call NotificationPlacing a Call Dtmf Signaling Terminating a CallHeadset and Speakerphone Usage Hold and Multiple Lines Teledex IP250D User’s Guide SIP/MGCP Forwarding ALL Calls Muting a CallTransferring a Call Redialing the Last Number DialedChanging Ringing Sounds Using the Msgs KEYConfiguring Local Speed Dial Numbers Making Conference CallsNetwork Troubleshooting Troubleshooting and CareBasic Troubleshooting Measures General TroubleshootingSymptom SIP-SPECIFIC Issues MGCP-SPECIFIC IssuesExecuting the Downloader Application Cleaning the IP250DUsing the Downloader Application Downloader ApplicationAppendix B Safe Bootup Modes Appendix a Determining the IP AddressDownload of the new firmware image ’SAFE’ Modes on AN IP Phone Appendix C Restoring Factory DefaultsAppendix D Dial Plans Appendix E Tone and Ring Cadence Configuration Tone ConfigurationSample Dial Plans CUSTOM3 CUSTOM4 CUSTOM5 CUSTOM6 CUSTOM7 CUSTOM8 CUSTOM9 Example Tone ConfigurationsExample Ring Cadence Configuration Ring Cadence ConfigurationAppendix F IP250D Product Specifications Appendix G Product Support