Config Menu ⇒ Codes
Codes Category
In this category are choices that allow you to determine the printer’s response to certain conditions and to assign values to parameters that are used by other commands or escape sequences. Use the Arrow and Enter keys to select Menu => Config Menu => Codes to get here.
Auto LF (Line Feed)
Auto LF causes the printer to perform a Line Feed each time it receives a Carriage Return Control Code. This option is available for host systems that cannot send a Line Feed Control Code.
Some computers automatically generate a Line Feed of their own at the right margin. If your system does this and if Auto LF is enabled, it will result in a
Auto CR (Carriage Return)
Auto CR allows the printer to perform a Carriage Return (moves print location to the left margin) when it receives either a Line Feed or Vertical Tab Control Code. The default value is dependent on the emulation (see the list on page 3- 59 under Ser/Par Emul).
Line Wrap
If the printer gets to the right margin without receiving a paper movement command, the Line Wrap parameter dictates how the rest of the data will be treated. If Line Wrap is OFF the excess characters are lost. If Line Wrap is ON, printer response is determined by the Wrap Line Feed (see below).
If Line Wrap is ON and Wrap LF is OFF, the printer performs a Carriage Return only and overprinting can result.
If Line Wrap is ON and Wrap LF is ON, the printer performs a Carriage Return plus a Line Feed and excess characters are printed on a new line at the left margin.
The default value is dependent on the emulation (see the list on page
Wrap Line Feed
This parameter works in conjunction with the Line Wrap parameter above. The default value is dependent on the emulation (see the list on page