Star Manufacturing LC-4522 user manual Opening the front cover, Removing the protective materials

Page 7

4 Printer Setup

Opening the front cover

o Lift up on the front cover and swing it open until it stops.

o To close the front cover, simply lower it back into place.

Caution!

The tear assist edge is rather sharp. Take care to avoid injuring your hands.

Note:

You can completely remove the front cover from the printer or you can stand it up. You should normally leave the front cover closed, because it protects against objects getting into the printer, and it cuts down on printer noise.

Removing the protective materials

Two small p ieces of packing material are inserted into the printer to protect components during shipping. Be sure to remove them before using the printer. o Open the rear cover by pushing it back so that the cover swings back and down.

Image 7

Contents LC-4522 Contents Using the EDS Mode Choosing a place for the printer Printer SetupUnpacking the printer Printer SetupGeneral guide General guideRemoving the protective materials Opening the front coverRemoving the protective m aterials Installing the ribbon cassette Installing the platen knobInstalling the ribbon cassette Removing the ribbon cassette Installing the paper guide Installing the paper guideStanding up the paper guide Connecting to a power outlet and turning power on and off Connecting to a power outlet and turning power on and offLoading fanfold paper Loading fanfold paper Printer Setup Loading fanfold paper Printing on fanfold paper Unparking fanfold paper Parking fanfold paperParking fanfold paper Connecting to your computer Using the tear-off functionPage Control Panel Operations Switching between on-line and off-lineSelecting a Print Quality Entering the Print Quality Lock ModeSelecting a font Entering the Multi-part Mode Micro feed Line feedPaper eject cut-sheet paper Form feed fanfold paperSelecting the Quiet Print Mode Setting the top of form positionTear-off function fanfold paper Changing the auto load position Changing the auto load positionClearing the printer’s buffer Saving a macroInitializing the printer Initializing the printerEntering the EDS Mode About EDS Mode settingsUsing the EDS Mode Selecting a bank Changing a switch settingSelecting a switch Selecting a bankExiting the EDS Mode Printing the current switch settingsEDS Mode Settings EDS Mode SettingsSwitches 3, 4, 5 Print Pitch Switch 6 Quiet modeSwitch 7 Not Used Switches 1,2 Print modeSwitch 5 FF command selection Friction mode only Switches 1,2 Multi-Part ModeSwitch 3 Auto Tear off Long Switch 4 Skip over perforation Tractor mode onlySwitches 4,5 Reserved Switch 6 Print Width Switch 1 Character TableSwitch 2 Character Set Switch 3 Zero StyleSwitches 1,2,3,4 Page Length Tractor Mode Switches 1,2,3,4 Page Length Friction ModeSwitch 5 Top Margin Switches 6,7 Not UsedSwitch 4 Paper Out Detector Switch 1 CR Centering at topSwitch 2 CR Centering at seem line Tractor mode only Switch 3 CR Centering PositionSwitch 5 Strobe timing Switch 5 BuzzerSwitch 6 Print direction command Switches 1, 2, 3, 4 International Character SetSwitches 1, 2, 3, 4, 5 Code Switch 6 Saving Control Panel Status Setting up for printing with MS-DOS Setting up for printing with MS-DOSCut-Sheet Paper with Optional Automatic Sheet Feeder Selecting paper typesPaper Handling Cut-Sheet Paper Manual FeedLabels Fanfold PaperAdjusting for paper thickness Adjusting for paper thicknessManual sheet feeding Automatic fanfold feedingClearing paper jams Clearing paper jams