SOYO SY-5S manual Sound Settings J4, J5, J2, WAKE-ON-LAN Connector JP44, Cmos Clear Jumper JP5

Hardware Setup SY-5STM

2-4 SOUND SETTINGS (J4, J5, J2)

The onboard audio features of your mainboard are controlled by

jumpers J4, J5, J2.

Choose the available sound options among the following table:

Sound Settings	J4	J5	J2
Onboard Sound: Enable *	open*	open*
Onboard Sound: Disable	short	short
Microphone: Stereo *			short*
Microphone: Mono			open

* Starred items refer to default settings.

2-5 WAKE-ON-LAN CONNECTOR (JP44)

Attach the 3-pin connector from the LAN card which supports the Wake-On-LAN (WOL) function to the JP44 connector on the mainboard. This WOL function lets users wake up the connected computer through the LAN card.

Please install according to the following pin assignment:

Wake-On-LAN

JP44 Pin Assignment

5V

GND

SENSOR

1 2 3

2-6 CMOS CLEAR JUMPER (JP5)

Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5, and then by shorting pin 1-2 to retain new settings. This jumper can be easily identified by its white colored cap.

CMOS Clearing	Clear CMOS Data	Retain CMOS Data
		(Default)

JP5 Setting

Short pin 2-3 for a few seconds to clear the CMOS

1 2 3

Short pin 1-2
to retain new	1 2 3
settings

Note: You must unplug the ATX power cable from the ATX power connector when performing the CMOS Clear operation.

35