Seiko FB 390 user manual Restoring Factory Printer Settings, Using the Self Test Functions

Restoring Factory Printer Settings

You can restore to the factory printer settings without having to work through the Setup Menu System to reset the menus.

To restore to the factory settings:

1.Make sure that the printer is ONLINE

2.Press and hold down the ONLINE and COPY keys on the control panel for 3 seconds.

The LED’s of the POWER and ONLINE on the control panel flash 3 times respectively at the same time and the printer makes a beep to confirm that the printer’s factory settings have been restored.

3.Release the keys and switch the printer off and on again.

After these steps, the printer’s factory settings work.

Using the Self Test Functions

Slide Pattern Printing Test

One page printing of ASCII slide pattern is performed by turning power on, while pressing the LF/FF key.

Continuous printing of ASCII slide pattern is performed by turning power on, while pressing the ON- LINE and PARK/LOAD keys.

ASCII TEST MODE

Version: 390V X.X 20XX/XX/XX

!”#$%&’()*+,-./10123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_’abcdefghijklm !”#$%&’()*+,-./10123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_’abcdefghijklmn ”#$%&’()*+,-./10123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_’abcdefghijklmno

Figure 5-4 The former of English self-test

Maintenance Printing Test (H pattern)

One page printing of H pattern is performed by turning power on, while pressing the ONLINE and LF/FF keys.

Continuous printing of H pattern is performed by turning power on, while pressing the COPY key.

23