Seiko TM-U590/U590P manual

Page 21

CAUTIONS:

When connecting or disconnecting the power supply from the printer, make sure that the power supply is not plugged into an electrical outlet. Otherwise you may damage the power supply or the printer.

If the power supply’s rated voltage and your outlet’s voltage do not match, contact your dealer for assistance. Do not plug in the power cord. Otherwise you may damage the power supply or the printer.

1.Make sure that the printer’s power switch is turned off, and the power supply’s power cord is unplugged from the electrical outlet.

2.Check the label on the power supply to make sure that the voltage required by the power supply matches that of your electrical outlet.

3.Plug in the power supply’s cable as shown below. Notice that the flat side of the plug faces down.

Note:

To remove the DC cable connector, make sure that the power supply’s power cord is unplugged; then grasp the connector at the arrow and pull it straight out.

Setting Up the Printer 1-9

Image 21

Contents TM-U590/U590P Labels Printer Parts and LabelsSolving Problems Setting Up the PrinterQuick Reference Validating and Verifying ChecksPage FCC Compliance Statement For American UsersIii Declaration of Conformity EMI and Safety Standards Applied Setting Up and Using About This ManualReference Accessory FeaturesIntroduction OptionsOrdering Ribbon Cassettes Contents Appendix B Epson Sales Subsidiaries Unpacking Setting Up the PrinterRemoving the protective material 2Setting Up the PrinterConnecting the computer Connecting the Cables and Grounding the Printer4Setting Up the Printer Connecting the Drawer Anschließen der Lade 6Setting Up the PrinterGrounding the Printer Connecting the Display Module8Setting Up the Printer Connecting the Power SupplyPage 10Setting Up the Printer Installing the Ribbon CassetteKnob 12Setting Up the Printer Using the Power Switch CoverSelf Test Running the self testCompleted DIP Switch SettingsRemoving the Paper Guide Slide the paper guide to the left to remove it Using the Printer Using the PrinterOperating the Control Panels Control PanelIndicator lights 2Using the PrinterPanel lights Slip Paper Handling Using the Micr Reader Option 4Using the PrinterReading Micr characters on personal checks Using the Printer Troubleshooting TroubleshootingGeneral problems Printing problemsPrinter sounds like it is printing, but nothing is printed 2TroubleshootingPrintout is faint Line of dots is missing in the printoutPaper handling problems Cleaning the Optional Micr MechanismMica cleaning method Recommended Cleaning procedure4Troubleshooting Adhesive Cleaning SheetCommand code sequence Explanatin of a cleaning sheetMoistened Cleaning sheet Adhesice cleaning sheet Refer to FigureHexadecimal Dump 6TroubleshootingPrinting Specifications Reference InformationPaper Micr Reader Option Ribbon SpecificationsPaper feed method Paper SpecificationsPaper feed pitch Paper feed speedAmbient temperature and copy capability Paper4Reference Information Copy capability and paper thickness 6Reference Information Reference Information Reliability Electrical CharacteristicsMtbf Mcbf Temperature Environmental ConditionsHumidity Setting the DIP Switches Dip Switch SettingDIP switch functions Serial interface specification2Dip Switch Setting Dip Switch Setting A-3 Parallel interface specification4Dip Switch Setting Changing the DIP switch settingsEpson Sales Subsidiaries B-1 Epson Sales Subsidiaries2EPSON Sales Subsidiaries