Seiko TM-U590/U590P manual DIP Switch Settings, Completed

2.While holding down the REVERSE button, turn on the printer to begin the self test. (The SLIP light blinks.)

3.Feed a sheet of slip paper into the printer. The printer loads the paper automatically, prints the printer settings, and then ejects the paper.

4.Remove the paper from the printer and feed another sheet of slip paper into the printer to print characters from the character table. Continue to feed slip paper into the printer until the self test prints the following:

***completed***

The printer is ready to receive data as soon as it completes the self test.

Note:

If you want to pause the self test manually, press the REVERSE button. Press the REVERSE button again to continue the self test.

DIP Switch Settings

The TM-U590/U590P is set up at the factory to be appropriate for almost all users. It does, however, offer some settings for users with special requirements.

It has DIP switches that allow you to change communication settings, such as handshaking and parity check, as well as connection to a customer display.

See Appendix A if you need to make any changes.

Setting Up the Printer 1-13