Installing and Configuring the Module
|
|
|
|
|
| modsoft |
|
|
|
|
| |
Hex |
| Dec | Bin |
| Goto |
|
|
| Lev 8 |
|
| Quit |
F1 |
| F2 | F3 |
| F4 | F5 | F6 | F7 | F8 | OFF | F9 | |
|
|
|
| Quantum TCP/IP CONFIG EXT. |
|
|
| Screen 1 / 6 | ||||
Ethernet Framing Type: Ethernet II |
|
|
|
|
|
|
| |||||
Quantum Backplane Slot: | 0 |
|
|
|
|
|
|
|
| |||
Internet Address: |
|
|
|
|
| B4. B3. B2. B1 |
|
|
| |||
|
|
|
|
|
|
|
|
|
|
| ||
(B4) | : 0 |
| DEC |
|
| Note: 000.000.000.000 |
|
|
| |||
(B3) | : 0 |
| DEC |
|
|
| represents the TCP/IP |
|
| |||
(B2) | : 0 |
| DEC |
|
|
| Board Default |
|
|
| ||
(B1) | : | 0 |
| DEC |
|
|
| Internet Address |
|
|
| |
Default Gateway Address: |
|
|
| G4. G3. G2. G1 |
|
|
| |||||
(G4) : 0 |
| DEC |
|
| Note: 000.000.000.000 |
|
|
| ||||
(G3) : 0 |
| DEC |
|
|
| represents the TCP/IP |
|
| ||||
(G2) : 0 |
| DEC |
|
|
| Board Default |
|
|
| |||
(G1) : 0 |
| DEC |
|
|
| Gateway Address |
|
|
| |||
SubNetwork MASK: | FFFFFF00 | HEX |
|
|
|
|
|
|
| |||
|
|
|
|
| PgDn/Up to next/prev Screen |
|
|
|
| |||
Figure 14 Configuration Extension Screen
2.4.1Selecting the Ethernet Framing Type
You may choose between Ethernet II and IEEE 802.3, depending on your system. The default choice is Ethernet II.
If you are using the configuration extension to change the framing to IEEE 802.3, do not forget to designate the backplane slot number on the next line. Without the slot number, the system will not record the change in framing.
2.4.2Assigning a Slot Number
To activate the configuration extension screen, you must enter the backplane slot number on the second line. This is the slot where you have mounted or intend to mount the Ethernet web embedded serve module. The slots are numbered from left to right, from one to x.
Note: If you do not enter the slot number, the system will ignore any other data you enter on this screen.
840 USE 115 00 Version 1.0 | 21 |