The MSTR Instruction
3.2.10Reset Option Module MSTR Operation
The Reset Option Module operation (type 10 in the displayed register of the top node) causes a Quantum web embedded server module to enter a reset cycle to reset its operational environment.
Control Block | The registers in the MSTR control block (the top node) contain the Reset Option | ||
Utilization | Module information as described in the following table: | ||
|
|
|
|
| Register | Function | Content |
|
|
|
|
| Displayed | Operation Type | 10 |
|
|
|
|
| First implied | Error status | Displays a hex value indicating an MSTR error, |
|
|
| when relevant. |
|
|
|
|
| Second implied | Not applicable |
|
|
|
|
|
| Third implied | Not applicable |
|
|
|
|
|
| Fourth implied | Low byte | Quantum backplane slot address of the web |
|
|
| embedded server module. |
|
|
|
|
| Fifth ... Eighth | Not applicable |
|
| implied |
|
|
|
|
|
|
3.2.11Read CTE (Config Extension Table) MSTR Operation
The Read CTE operation (type 11 in the displayed register of the top node) reads a given number of bytes from the Ethernet configuration extension table to the indicated buffer in PLC memory. The bytes to be read begin at a byte offset from the beginning of the CTE. The content of the Ethernet CTE table is displayed in the middle node of the MSTR block.
840 USE 115 00 Version 1.0 | 37 |