Unitech PT-500 manual

Page 2

NOTICE

The unit is equipped with a NiMH battery pack. It is possible that the customer might receive the battery pack in a discharged (dead) state due to product storage. This is normal.

In the above situation, plug the

9V/500mA AC-DC adapter into the PT500 and an available 110V electrical outlet, switch on the PT500, and fully charge the NiMH battery pack for 14-16 hours. Or place the PT500 into the optional charging cradle for 3 hours before using the unit.

During the initial charging, switching on the PT500 is highly recommended. In addition to charging the main NiMH battery pack, this will also simultaneously charge up the backup lithium battery.

1

Image 2
Contents USER’S Guide Page Table of Content Chapter InstallationOverview Application Development Technical SpecificationSoftware System UPC, EAN, CODE39, I 2 of 5, CodbarBatteries Power On and Off the PT-500Main Battery Backup Battery Using the Keypad Turn on and off of the terminal Triggering the Scanner Module Interface PortOptional Charging and Communication Cradle Side Spare CommPower MainOperation Ready Mode Page System Mode RUN MenuTime Menu SET MenuMain Menu Code Menu Fnky Menu Comm MenuBeep Menu Define F1 Misc Menu DIR Menu DEL MenuDiag KBD Diag MenuDiag LCD Init Menu Diag COMDiag MEM EasyJob Mode InputDump PurgeFormat OFF /ONCRLF/NONE/CR/LF MMDDYYYYhhmmssIf ON, each record will include a Xlink EXE Application ModeEXE Xlib EXEASM BAT Maininfo COMSetenv BAT LNK BAT