Unitech manual Power On and Off the PT-500, Batteries, Main Battery

Page 6

Chapter 2 Installation

2.1 Power On and Off the PT-500

Press the Power Key ? located near the bottom left corner to turn the terminal on and off. As a safeguard, the unit can only be turned off by pressing the power key ? for at least 3 seconds.

2.2 Batteries

Main Battery

The PT-500 operates with either a rechargeable nickel metal-hydride (NiMH) battery pack or three standard AA size alkaline batteries. When the main battery is running low, the LCD display will start blinking. If the unit is switched off and on again, a warning message stating “MAIN BATTERY LOW” will appear on the LCD display.

NiMH Battery Pack

Battery Installation Procedure:

1.Turn off the terminal and place it face down.

2.Move the battery compartment latch to the left to open. Remove the battery cover.

3.Insert the main batteries:

?NiMH battery:

Place the battery with label facing up; firmly push the whole pack inside the compartment.

?Alkaline batteries:

5

Image 6
Contents USER’S Guide Page Table of Content Chapter InstallationOverview Application Development Technical SpecificationSoftware System UPC, EAN, CODE39, I 2 of 5, CodbarPower On and Off the PT-500 Main BatteryBatteries Backup Battery Using the Keypad Turn on and off of the terminal Triggering the Scanner Module Interface PortOptional Charging and Communication Cradle Side Spare CommPower MainOperation Ready Mode Page System Mode RUN MenuSET Menu Main MenuTime Menu Code Menu Comm Menu Beep MenuFnky Menu Define F1 Misc Menu DIR Menu DEL MenuDiag Menu Diag LCDDiag KBD Diag COM Diag MEMInit Menu EasyJob Mode InputDump PurgeFormat OFF /ONCRLF/NONE/CR/LF MMDDYYYYhhmmssIf ON, each record will include a Xlink EXE Application ModeEXE Xlib EXEASM BAT Maininfo COMSetenv BAT LNK BAT