Unitech PT-500 manual Using the Keypad

Page 8

When the PT-500 is switched on and the Lithium battery is discharged, the following low backup battery warning message will be displayed on the PT-500 LCD:

BACKUP BATTERY LOW!

In this situation you should upload your data from the PT- 500 to a PC and have the Lithium battery replaced. Contact your local sales or service representative for replacement of the Lithium battery.

Note: Data may not be backed up and data loss may occur if both the main battery and the Lithium battery are discharged.

2.3 Using the Keypad

The Keypad of the PT-500 consists of 36 rubber keys and one large scanner trigger button. The keypad layout is shown in the following picture.

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents USER’S Guide Page Table of Content Chapter InstallationOverview Technical Specification Software SystemApplication Development UPC, EAN, CODE39, I 2 of 5, CodbarBatteries Power On and Off the PT-500Main Battery Backup Battery Using the Keypad Turn on and off of the terminal Triggering the Scanner Module Interface PortOptional Charging and Communication Cradle Side Spare CommPower MainOperation Ready Mode Page System Mode RUN MenuTime Menu SET MenuMain Menu Code Menu Fnky Menu Comm MenuBeep Menu Define F1 Misc Menu DIR Menu DEL MenuDiag KBD Diag MenuDiag LCD Init Menu Diag COMDiag MEM EasyJob Mode InputDump PurgeFormat OFF /ONCRLF/NONE/CR/LF MMDDYYYYhhmmssIf ON, each record will include a Application Mode EXEXlink EXE Xlib EXEMaininfo COM Setenv BATASM BAT LNK BAT
Top Page Image Contents