Unitech PT-500 manual Diag Menu, Diag LCD, Diag KBD

Page 25

Press [EXIT] to exit to the previous menu.

5. DIAG MENU

Select [5-DIAG] to diagnose the PT-500 to determine if there are any hardware problems.

<DIAG MENU >

1-LCD 2-KBD

3-COM 4-MEM

Select [1] to diagnose LCD

Select [2] to diagnose Keypad

Select [3] to diagnose RS232 port

Select [4] to diagnose Memory

Select [Exit] to return to the previous menu

Note: Multi-Point Protocol will be disabled temporally while the system is diagnosing itself.

1. DIAG LCD

The LCD will become clear, then black, and then will return to the Diag Menu display.

2.DIAG KBD

<DIAG MENU >

Key Pressed:

_

Keypad input will be displayed on the bottom left corner. Press [Exit] key to return to the previous menu.

24

Image 25
Contents USER’S Guide Page Chapter Installation Table of ContentOverview Software System Technical SpecificationApplication Development UPC, EAN, CODE39, I 2 of 5, CodbarMain Battery Power On and Off the PT-500Batteries Backup Battery Using the Keypad Turn on and off of the terminal Interface Port Triggering the Scanner ModuleOptional Charging and Communication Cradle Side Comm SpareMain PowerOperation Ready Mode Page RUN Menu System ModeMain Menu SET MenuTime Menu Code Menu Beep Menu Comm MenuFnky Menu Define F1 Misc Menu DEL Menu DIR MenuDiag LCD Diag MenuDiag KBD Diag MEM Diag COMInit Menu Input EasyJob ModePurge DumpOFF /ON FormatMMDDYYYYhhmmss CRLF/NONE/CR/LFIf ON, each record will include a EXE Application ModeXlink EXE Xlib EXESetenv BAT Maininfo COMASM BAT LNK BAT