Universal Laser Systems CLP-100NI-NPRT manual Knurled Drive Wheel Cover is very loose fitting

QUICK START

3 -While holding the Knurled Drive Wheel Cover “J” in place, remove the Knurled Cover Retaining Knob “K” by turning it counter-clockwise.

The Cover Retaining Knob holds the entire inking system together and other parts may fall free from the coder if not held securely when this knob is removed.

4 -Hold the Inking System Cover “L” in place and remove the Knurled Drive Wheel Cover “J”.

The Knurled Drive Wheel Cover is very loose fitting.

Note: The flat on the side of the Drive Wheel Cover is aligned towards the print drum. During reassembly, this must be replaced in the same position.

5 -Continue to hold the Inking System Cover and Remove the Knurled Drive Wheel “G”.

The Knurled Drive Wheel rests on top of the Transfer Roller and is installed over 3 stainless steel drive pins which pro- trude through 3 mating holes in the Drive Wheel.

6 -Carefully pull the Inking System Cover “L” directly away from the Inking System Baseplate “M”. Do not let the cover drag across the surface of the Transfer Roller “N”.

The Transfer Roll Surface is a finely engraved Delrin plastic material which can be easily scratched. When assembled, the Transfer Roll resides in a very close fitting cavity in the Inking System Cover.

FIGURE 15

FIGURE 16

FIGURE 17

FIGURE 18

11