Universal Laser Systems CLP-100NI-NPRT manual Inking System Assembly

MAINTENANCE

INKING SYSTEM ASSEMBLY

The following steps will guide you through the Ink Roll Eccentric Assembly.

1 - Install the O-Ring in the groove of the Eccentric flange, then install one of the white delrin washers on the Eccen- tric.

ECCENTRIC O-RING

FIGURE 74

2 - Apply a thin coating of grease to the O-Ring and the Ec- centric to approximately 1/2” from the flange.

Automotive wheel bearing grease is recommended.

FIGURE 75

3 - Insert the Eccentric into the Inking System Cover. Rotate and pull the Eccentric from the opposite side until the o- ring slips into the bore. When fully seated, the flange of the eccentric will be approximately 0.010” above the sur- face of the cover. Rotate the Eccentric and align the dimple on the Eccentric flange with the dimple in the cover.

4 - Install the second white delrin washer over the Eccentric.

ALIGN DIMPLES

FIGURE 76

FIGURE 77

37