Universal Laser Systems CLP-100NI-NPRT manual

Page 13

QUICK START

11 -Replace the Knurled Drive Wheel “G” by aligning the 3 small holes with the 3 stainless drive pins on the top of the Transfer Roll “N” and pressing the Drive Wheel onto the Transfer Roll.

The tops of the stainless pins will be flush with the top of the

Drive Wheel when seated properly.

FIGURE 23

12 - Replace the Knurled Drive Wheel Cover “J” and rotate it into position with the flat edge directly facing the Print Drum.

Hold the Drive Wheel Cover and Inking System Cover in place.

FIGURE 24

13 - Replace the Knurled Cover Retaining Knob “K” and lightly tighten. Do not over tighten this knob or you may bend the top of the Knurled Drive Wheel Cover “J” and cause it to bind against the Knurled Drive Wheel. Now retighten the Pivot Arm Knurled Knob.

The Cover Retaining Knob should be just tight enough to keep the Inking System Assembly together and prevent the Drive Wheel Cover from rotating out of position.

FIGURE 25

13

Image 13
Contents Stenciling & Marking Installation Operation MaintenanceImportant Note Preface SpecificationsPreface Coder SpecificationsQuick Start Conveyor Line Printer Specifications TOP Mount Series SpecificationsModel Shown CLP-200NI-NPLS Conveyor Line Printer Specifications Side Mount SeriesIndexing and NON-INDEXING Models Mounting ConfigurationRIBtype Printing Dies XF Neoprene INK Rolls INK RollsType MT INK Rolls Quick Start Installing the Inking System AssemblyInstalling the PRE-INKED Roll Knurled Drive Wheel Cover is very loose fitting Quick Start Hold the Drive Wheel Cover and Inking System Cover in place Installing the Printing Dies Adjusting the INK Roll Eccentric Basic Principles of Operation Using the 4 OZ. Reservoir INK CartridgesNON-POROUS Inking System Selecting AN Appropriate INK INK Drying Time Considerations WEB Printing Mounting the Coder Special WEB Printing Applications Gang Mounting Carton Alignment Carton PrintingClearance 1/4 DIE Positioning for Indexing Applications Carton Printing PRE-INKING a NEW INK Roll MaintenanceCleaning the Coder Cleaning the Transfer RollCleaning the Printing Dies Pivot ARM & Inking System Assembly Conversion Tension ARM Assembly Conversion Print Drum Index Mechanism Conversion Print Drum Axle Brass TIP Recess Area SET Screw Replacing Print Drum Index Springs Removing and Replacing Index Block B Lift Index Block B straight up to remove Inking System Assembly Maintenance MOUNTINGARM, CLP CE Guard NON-POROUS Conveyor Line Printer Assembly NON-POROUS Conveyor Line Printer Parts List NON-POROUS Conveyor Line Printer Inking System Assembly CLP NON-POROUS Inking System Baseplate NON-POROUS Conveyor Line Printer Inking System Parts ListFriction Bearer Ring Square CUT Snap Ring