Universal Laser Systems CLP-100NI-NPRT manual Removing and Replacing Index Block B

Page 35

MAINTENANCE

4- Holding onto the Index Assembly Block “A”, pull the Index Assembly Block “C” off the guide shafts (Figure 68). Remove the Drum Index Springs (Figure 69)

FIGURE 68

FIGURE 69

5- Install new Index Springs over the stainless steel guide shafts and replace Index Block “C”.

Ensure that Block “C” is installed in the same orientation as Block “A” with the flange of the white bushing (the large diameter end) facing in the same direction.

6- Reinstall the Index Spring Assembly in the Print Drum with the flanges of the white bushings facing the open end of the Print Drum.

7- Reinstall the two Snap Rings.

REMOVING AND REPLACING INDEX BLOCK “B”

1- To remove Index Block “B” from the Print Drum, roll down the RIBtype® Drum Cover directly behind the Index Block to expose the Index Assembly Mounting Screw. Using a screw driver, turn the Mounting Screw in a clockwise direction un- til the Index Block becomes loose and can be removed.

FIGURE 70

35

Image 35
Contents Stenciling & Marking Installation Operation MaintenanceImportant Note Preface SpecificationsQuick Start Coder SpecificationsPreface Conveyor Line Printer Specifications TOP Mount Series SpecificationsModel Shown CLP-200NI-NPLS Conveyor Line Printer Specifications Side Mount SeriesIndexing and NON-INDEXING Models Mounting ConfigurationRIBtype Printing Dies Type MT INK Rolls INK RollsXF Neoprene INK Rolls Quick Start Installing the Inking System AssemblyInstalling the PRE-INKED Roll Knurled Drive Wheel Cover is very loose fitting Quick Start Hold the Drive Wheel Cover and Inking System Cover in place Installing the Printing Dies Adjusting the INK Roll Eccentric NON-POROUS Inking System Using the 4 OZ. Reservoir INK CartridgesBasic Principles of Operation Selecting AN Appropriate INK INK Drying Time Considerations WEB Printing Mounting the Coder Special WEB Printing Applications Gang Mounting Carton Alignment Carton PrintingClearance 1/4 DIE Positioning for Indexing Applications Carton Printing PRE-INKING a NEW INK Roll MaintenanceCleaning the Coder Cleaning the Transfer RollCleaning the Printing Dies Pivot ARM & Inking System Assembly Conversion Tension ARM Assembly Conversion Print Drum Index Mechanism Conversion Print Drum Axle Brass TIP Recess Area SET Screw Replacing Print Drum Index Springs Removing and Replacing Index Block B Lift Index Block B straight up to remove Inking System Assembly Maintenance MOUNTINGARM, CLP CE Guard NON-POROUS Conveyor Line Printer Assembly NON-POROUS Conveyor Line Printer Parts List NON-POROUS Conveyor Line Printer Inking System Assembly CLP NON-POROUS Inking System Baseplate NON-POROUS Conveyor Line Printer Inking System Parts ListFriction Bearer Ring Square CUT Snap Ring