Viking PSFEM1xxxGQxxx manual Extended Smart Attributes, S.M.A.R.T. Command Set, Value hex Command

Table 5-4: S.M.A.R.T. Command Set

Value (hex)	Command
00-CF	Reserved
D0	S.M.A.R.T. read attributes
D1*	S.M.A.R.T. read threshold
D2	S.M.A.R.T. enable/disable attribute autosave
D3*	S.M.A.R.T. save attribute values
D4	S.M.A.R.T. execute off-line immediate
D5	S.M.A.R.T. read log sector
D6	S.M.A.R.T. write log sector
D7*	S.M.A.R.T. write attribute threshold
D8	S.M.A.R.T. enable operations
D9	S.M.A.R.T. disable operations
DA	S.M.A.R.T. return status
DB	S.M.A.R.T. enable/disable automatic off-line
DC-FF	Reserved (Vendor Specific)

* Note that D1, D3, and D7 have been made obsolete in the

ATA-8 specification.

5.1.2.1Extended SMART Attributes

Table 5-5: Extended SMART Attribute Table

SMART Attribute
ID	Description
01h	Read Error Rate
05h	Reallocated sector Count
09h	Power-On hours Count
	Drive Power Cycle Count (Number of accumulation of power
0Ch	on/off cycles)
20h	Write Protect
A7h	SSD Protect Mode
	SATA PHY Error Count (only record from power on, when power
	off this value will clear to zero) this value include all PHY error
	count, ex data FIS CRC ,code error, disparity error ,command
A8h	FIS CRC
A9h	Total Bad Block Count
	Max Bad Block Count (will show early bad and later bad block
AAh	count)
ACh	Erase Fail Count
ADh	Erase count (average, max, erase count)
B1h	Wear Range delta
B5h	Program Fail Count

Manual

PSFEM1xxxGQxxx

Revision B www.vikingtechnology.com

9/11/2014

Viking Technology

Page 28 of 33