West Bend Back to Basics UX-CC500 manual FCC Regulatory Information, 122

Page 124

FCC Regulatory Information

FCC Regulatory Information

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the rear of this equipment is a label that contains, among other information, a product identifier in the format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.

A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is also compliant. See installation instructions for details. This equipment connects to the telephone network through a standard USOC RJ-11C network interface jack.

The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. For products approved after July 23, 2001, the REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point (e.g., 03 is a REN of 0.3). For earlier products, the REN is separately shown on the label.

If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn't practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.

The telephone company may make changes in its facilities, equipment, operations or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.

If trouble is experienced with this equipment, or for repair or warranty information, please contact Sharp’s Customer Assistance Center. The number is 1-877-794-8675. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.

This equipment may not be used on coin service provided by the telephone company. Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information.

If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this equipment ID does not disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer.

This equipment is hearing-aid compatible.

When programming and/or making test calls to emergency numbers:

Remain on the line and briefly explain to the dispatcher the reason for the call.

Perform such activities in the off-peak hours, such as early morning or late evening.

122

Image 124
Contents UX-CC500 Important Notice Fax machine and general specifications IntroductionPower requirements Operating temperaturePower consumption Dimensions withoutCordless handset specifications Important safety informationBattery Health care facilities and equipmentTable of Contents Replacing the Cordless Handset Battery Problems and SolutionsMessages and Signals Clearing Paper JamsLook at the Operation Panel Fax machineResolution / Reception Mode key Stop keyCOPY/HELP key START/MEMORY keyAntenna Display Cordless handsetFUNCTION/PAUSE key Talk key Review left arrow keyPlay NEW key Start keyBattery cover Reception keyHOLD/ERASE key Redial keyInstallation Unpacking ChecklistSetting Up Setting UpSelecting a location for the fax machine Connecting the handset Connecting the power cordConnecting the telephone line cord Attach the paper tray and paper tray extension About condensationConnecting the cordless handset charger Raising the base antennaInstalling the battery and charging the cordless handset Aluminum sash Metal Reinforced concrete Talking rangeEntering a name for the cordless handset Press Function once and 3 times on the fax machinePress 1 to select SET Press 1 is the ID numberConnecting a headset Accessory cordless handsetsPress START/MEMORY to store the name Press To exitLoading the Imaging Film Loading the Imaging FilmRemove the new roll of imaging film from its packaging Insert the green gearsInsert the film into the print CompartmentLoading Printing Paper Loading Printing PaperSetting the paper size Print contrast settingEntering Your Name and Fax Number Entering Your Name and Fax NumberPress Function once Times Enter your fax number by pressing the number keys max digits February, 12 for December, etc Example January Enter a two-digit number for the day 01 to Example the 5thSetting the Date and Time Daylight Saving TimeSetting the reception mode Setting the Reception ModeSetting the Reception Mode Volume Adjustment Fax Machine Volume Adjustment Fax MachinePress or to select the desired volume level SpeakerVolume Adjustment Cordless Handset Volume Adjustment Cordless HandsetFax machine ringer Cordless handset receiver volume Cordless handset ringerUsing the Cordless Handset Making a Phone CallPutting a Call on Hold Receiving a Phone CallReceiving a Phone Call Storing and Using Auto-Dial Numbers Receiving a Fax Using the Cordless HandsetReceiving a Fax Using the Cordless Handset Storing and Using Auto-Dial Numbers Dialing an auto-dial number Press StartReturn to to store another number, or press OFF to exit Press Search onceEditing an auto-dial number If a pause is required between anyClearing an auto-dial number Press OFF to exitUsing the Intercom Feature RedialPaging the fax machine from a cordless handset RedialUsing the Intercom Feature Press 0 on the cordless handset toSelect the fax machine Fax machine ringsSelected cordless handset rings Other person presses any key except OFF on the cordlessTransferring Calls Transferring CallsDuring the call, press Intercom on the cordless handset During the call, press Intercom on Fax machine Changing the reception mode on the fax machine Mode appears in the displayPress /FLASH Or OFF to exit Remote Mode Until the desired receptionUsing the Answering System PressPersonal Box General BoxRecording an Outgoing Message Recording an Outgoing MessageExample of general outgoing message Example of personal outgoing messageSetting a Passcode for a Personal Box Setting a Passcode for a Personal BoxWhen finished, replace the handset or press To listen to an outgoing messageActivating the answering system Operating the Answering SystemOperating the Answering System Number of rings in TAD mode Toll Saver function Toll Saver on Toll Saver OFFListening to received messages at the fax machine Press PlayErasing received messages Recording memosRecording phone conversations Listening to messages from a cordless handsetPress /FLASH Skip To skip forward, pressSTAND-BY display To cancel, press 9 Wxyz Deleting all messages from a cordless handsetTo return to the STAND-BY display, press OFF or /FLASH Press DeleteOptional Answering System Settings Setting ICM timeOptional Answering System Settings Fax reception on TAD failureOGM only mode CPC Detection Press To turn on OGM only modePress To turn on CPC Detection Transfer Function Programming the transfer numberTransfer Function Press the number keys to enter the transfer numberChecking or erasing the transfer message Recording the transfer messagePress Memo once Once Press To turn on the Transfer Turning the Transfer function on and offFunction Remote Operations Remote code numberRemote Operations Press Function once and oncePress To turn on the Toll Saver Toll SaverFunction, or To turn it off Retrieving your messages Unless you press twice Changing the fax reception mode TAD mode FAX mode TEL modeOther remote operations CommentsRecording a new outgoing message Turning the Transfer function on or offChanging the transfer telephone number To turn Transfer off Press 9Recording a new transfer message To turn off OGM only mode Press 1 , 2 ,Recording a memo Sending Faxes Size and weightTransmittable Documents Other restrictions Loading the DocumentLoading the Document Resolution settings Adjusting the Resolution and ContrastAdjusting the Resolution and Contrast Contrast settings Load the documentsSending a Fax by Normal Dialing Sending a Fax by Normal DialingPick up the handset or press Speaker Listen for the dial tone Dial the number of the receivingStoring fax and phone numbers for automatic dialing Sending a Fax by Automatic DialingSending a Fax by Automatic Dialing Return to to store another number, or press Press 1 for Edit or 2 for Clear Editing and clearing auto-dial numbersMake the desired changes to the name Using an auto-dial number Return to to edit or clear another number, or pressReturn to the date and time display If you are sending a fax, load the documentsSending a fax by Direct Keypad Dialing Redial Automatic redialingError Correction Mode Press 1 to select YES, orSelect no Press to return to the date and time displaySending a Fax From Memory Broadcasting sending a fax to multiple destinationsSending a Fax From Memory If desired, pressMemory transmission If the memory becomes fullReceiving Faxes Using FAX ModeChanging the number of rings Using TEL Mode Using TEL ModeDisplay shows Receiving and then Replace the handsetFax Signal Receive Optional Reception SettingsOptional Reception Settings Reception Ratio Press To turn on the function, orPress To select AUTO, or 2 to Select 100%Substitute Reception to Memory Substitute Reception to MemoryMaking Copies Load the documents face down. Maximum of 10 pagesMaking Copies Copy Cut-offPress once and once Caller ID Requires Subscription to Service Special FunctionsHow Caller ID operates Caller ID Requires Subscription to ServiceDisplay messages When you have finished viewing the list Viewing the Caller ID listPress Twice Dialing and transmission begin FaxTo delete calls from the Caller ID list Viewing the Caller ID list from the cordless handsetTo cancel, press Erasing all calls using the cordless handsetPriority Call Blocking voice calls Distinctive Ring Requires Subscription to Service Distinctive Ring Requires Subscription to ServiceBlocking Reception of Unwanted Faxes Set the reception mode to FAXBlocking Reception of Unwanted Faxes Press or until the desired list appears in the display Once Printing ListsPress START/MEMORY to print the list Setup List Telephone Number ListMessage List Caller-ID List101 Transaction ReportHeadings in Transaction Report Transaction Report print condition 102Print head Maintenance103 Scanning glass and rollers Maintenance104 105 HousingFlip up the green levers on each side of the white roller Replacement battery Use only a Sharp UX-BA01 battery Replacing the Cordless Handset Battery106 Wiping the charger contacts Battery disposal107 Troubleshooting Problems and SolutionsLine error Problem SolutionProblems and Solutions Dialing and transmission problems109 Reception and copying problems 110General problems 111Cordless handset problems 112113 Messages and Signals Messages and SignalsDisplay messages fax machine 114115 FAX RX in Memory116 Over HeatDisplay messages cordless handset 117Audible signals 118Clearing Paper Jams Clearing a jammed documentClearing Paper Jams 119Clearing jammed printing paper 120Part distribution centers 121FCC Regulatory Information 122A R P 123Material Safety Data Sheet 2/2 124Quick Reference Guide 125Using the Cordless Phone 126Guía de referencia rá pida 127Uso del telé fono inalá mbrico 128Index 129Index 130Remote Operation Card Remote Commands Page END User Limited Warranty Important Service Information Page Sharp Corporation