Worth Data 802 RF user manual Opening screen can be bypassed upon power up. See Chapter

Upon power-up, the R/F Terminal displays the following opening screen:

802 TERMINAL 1XWFUnnn

ServerIP=nnn.nnn.nnn.nnn

DeviceIP=nnn.nnn.nnn.nnn

Ch:=n SSID=xxxxxxxxxxxx

WEP=128 Rnn

HIT ANY KEY

(The opening screen can be bypassed upon power up. See Chapter 2)

•The first line on the screen, 802 TERMINAL WFUnnn, gives the firmware revision number.

•Server IP either shows the Server's fixed TCPIP address; or if Device searches out the Server, shows 0.0.0.0.

•Device IP either shows the Device's fixed TCPIP address or if it is determined by a DHCP Server, shows 0.0.0.0.

•Ch:=nn shows the channel to start using, (the channel of the most frequently used Access Point, 01-11).

•SSID=xxxxxxxxxxxx refers to the first 12 characters of the up 32 ch character network name.

•WEP=128 or 64 or NO shows how the Device is configured with an encryption key.

•Rnn=the radio firmware version.

To move on to the first menu item, press any key on the R/F Terminal keypad.

The display now reads:

DEVICE SIGN ON -----	>1
SETUP MODE-----------	>2
SITE SURVEY-----------	>3

•Press the 1 key to initiate to a two-way communication host computer program through an Access Point.

•Press the 2 key to change the configuration of the Terminal Device.

•Press the 3 key to survey the intended site for adequate coverage.

This screen can be skipped (see Chapter 2; RF System Setup), causing the R/F Terminal to automatically enter DEVICE SIGN ON at power up.

1-5