Configure Monitor
AUTO SETUP
NOTE: After making changes in the Setup, the computer must be Rebooted to insure proper changes to the CONFIG.SYS and AUTOEXEC.BAT files.
NOTE: Before proceeding with the next section, it is very important that The Setup Diskette for Windows 95 or Windows 98 has been run.
NOTE: If your computer does not run with the Setup Diskette shipped with the monitor, refer to Manual Setup.
NOTE: The Auto Setup process only applies to the current screen mode. When a new mode is selected, repeat this section to reset the monitor.
Locate the operating system installed on the computer in the Table below and follow the appropriate instruc- tions. You may choose to run Auto Setup for each operating system that is used. This means that if sometimes the monitor is used while running any version of Windows and sometimes it is also used within DOS (not a DOS window), you must run Auto Setup for both Windows and DOS. You may run versions of Auto Setup in any order.
Before beginning Auto Setup for the computer:
•Make a backup copy of the Setup Diskettes supplied with the monitor.
•Make sure the computer’s video mode is set in the range of the supported screen resolution shown in the table in the Reference section.
Perform Auto Setup for each screen mode used.
15
Doc#