Configure Monitor
AUTO SETUP FOR WINDOWS 3.1, 95, 98 OR NT
NOTE: If the monitor is in standby mode (STANDBY ON), it may automati- cally turn off while you are waiting for it to warm up.
NOTE: The size and diversity of the dot pattern varies with the screen resolution.
NOTE: Position the mouse pointer at the bottom center of the screen. This allows Auto Setup to run properly.
1.Turn the monitor on first, then the computer. If the message CHECK SIGNAL CABLE is displayed. If nothing is displayed check:
•that the video interface cable is connected properly.
•the correct video adapter card is installed.
•the correct support display mode is selected for the computer.
2.Wait approximately 15 minutes, until the monitor warms up.
3.Drag the icon bar and tool bar, if they are displayed, to the bottom of the screen.
4.Insert the Setup Diskette into the diskette drive.
5.Check the operation system installed on your computer and follow the instructions from the table above.
6.When the test pattern appears, press the OSD Enter button 
at the bottom of the monitor to display the initial OSD menu.
16
Doc#