Z Microsystems 15 manual Troubleshooting, Causes and Corrective Action

Page 24

Troubleshooting

WARNING: Be sure to turn off the power before you perform any maintenance on the monitor.

CAUSES AND CORRECTIVE ACTION

NOTE: For image problems, you may want to run AUTO SETUP again before consulting to this section. In most cases, AUTO SETUP can fix the problems.

24

Doc# 27-0002UM Issued 7/99 Rev. 1.2

Image 24

Contents Command CO NSO L E Regulatory FCC InformationContents Shipment Contents System RequirementsProduct Description Precautions Starting PointTools Required Install Rails Install the Slides in the Cabinet FrameSlide Removal Install Rails Install Console Install the Command Console in the SlidesTest Installation and Make Adjustments Final Adjustments of the Command Console Setting UP Monitor Keyboard and Mouse Closing Console Closing Down the MonitorInstalling Cables Powering UPOperation Configure Monitor Setup for Windows 95 or WindowsAuto Setup Before beginning Auto Setup for the computerAuto Setup for Windows 3.1, 95, 98 or NT Configure Monitor Monitor Adjustments User Control FeaturesOn-Screen Display OSD Controls Initial Appearance of OSD OSD Functions Monitor Adjustments Monitor Adjustments Maintenance Clean MonitorTroubleshooting Causes and Corrective ActionTroubleshooting Display Modes Factory SET Display ModesPower Management Specifications AmlcdEM/RFI Support Further HelpProviding Feedback Compliance Y2K ComplianceDrawings Drawings Microsystems, Inc