Z Microsystems 15 manual Power Management

Page 27

Display Modes

POWER MANAGEMENT

NOTE: If the computer has previously been used with a CRT monitor and is currently configured to a display mode outside the range that the Flat Panel monitor can display, reattach the CRT monitor temporarily until the computer is reconfigured, preferably to 1024 x 768 at 60 Hz.

To benefit from power management, the monitor must be used in conjunc- tion with a computer that implements the Video Electronics Standards Association (VESA) Display Power Management Signaling (DPMS) Standard.

The power management feature is invoked when the computer recog- nizes that the mouse and keyboard have not been used for a user- definable period. There are several states as described in the table below.

It is recommended that the monitor be switched off at the end of each working day, or whenever it is expected to be unused for long periods during the day.

The following is the Power Manage- ment Table:

27

Doc# 27-0002UM Issued 7/99 Rev. 1.2

Image 27
Contents Command CO NSO L E FCC Information RegulatoryContents System Requirements Shipment ContentsProduct Description Precautions Starting PointTools Required Install Rails Install the Slides in the Cabinet FrameSlide Removal Install Rails Install Console Install the Command Console in the SlidesTest Installation and Make Adjustments Final Adjustments of the Command Console Setting UP Monitor Keyboard and Mouse Closing Down the Monitor Closing ConsoleInstalling Cables Powering UPOperation Setup for Windows 95 or Windows Configure MonitorBefore beginning Auto Setup for the computer Auto SetupAuto Setup for Windows 3.1, 95, 98 or NT Configure Monitor User Control Features Monitor AdjustmentsOn-Screen Display OSD Controls Initial Appearance of OSD OSD Functions Monitor Adjustments Monitor Adjustments Clean Monitor MaintenanceCauses and Corrective Action TroubleshootingTroubleshooting Factory SET Display Modes Display ModesPower Management Amlcd SpecificationsEM/RFI Further Help SupportProviding Feedback Y2K Compliance ComplianceDrawings Drawings Microsystems, Inc