Panasonic CF-VDM732U specifications Troubleshooting, Emergency Hole

Troubleshooting

The computer does not recognize		Check the settings by following the instructions in
the drive		“Preparations” (		page 7).
		Is the drive properly mounted in the multimedia
		pocket?
		Restart the computer.
The Multimedia pocket device		Is the disc loaded on the tray correctly?
status indicator	does not light	(	page 8)
Cannot play disc or read data		Is the disc bent, scratched, or dirty?
from it		An error may occur if, after the tray has been closed
		or operation has been resumed from the standby/
		hibernation modes, the drive is accessed before the
		Multimedia Pocket device status indicator				goes
		off. Also, an error may occur if the drive is ac-
		cessed by the application software automatically.
		In a case like this, remove the disc, re-insert it, and
		try again.
“B’s Recorder” and “B’s CLiP”		Is writing software other than “B’s Recorder” or
do not work properly		“B’s CLiP” installed?
		Uninstall the writing software other than “B’s Re-
		corder” or “B’s CLiP.”
		Windows XP
		Be sure to disable writing to CDs. (			page 11)
		Windows 2000
		Uninstall Adaptec CD-Burning Plug-in. (				page 11)
Cannot eject disc		Is the computer powered on?
		To remove a disc when the computer is powered
		off, insert a sharp object such as the bent-out tip of
		a paper clip into the emergency hole. Pushing it
		completely to the end will free the tray so that it
		can be pulled out.
			Emergency Hole

When using a software such as B’s CLiP that con- trols the disc removal, remove the disc while re- ferring to the software’s operating instructions.

If a disc with fingerprints or other dirt is used, you may not be able to remove it. Use a clean disc. ( page 6)

The disc tray does not close	Did you touch the eject button when you close the
	tray?

E

23