Panasonic DP-200 manual Contents Refer to Function Key, Reset Key, Clear Keys, Stop Key, 1 Key

Page 10

Control Panel

No

Contents

Refer to

 

Function Key

 

0

CUse when changing the paper size, initial values for functions (default

P.28 37

 

values) and key operator settings.

 

1

Reset Key

——

CResets all features to the initial power-on state.

 

 

2

Clear Keys

——

CClears the copy count in the display.

 

 

3

Stop Key

——

CStops the copy run.

 

 

4

2 in 1 Key

P.19

CFrom two 1-sided originals, side by side, to 1-sided copies.

 

 

 

2 Page Copy Key

 

5

CCopying two facing pages on a ledger size original on two separate

P.20

 

letter size sheets.

 

NOTE

CThe Control Panel displayed above shows only copier functions. Please refer to the

proper operating instructions for Facsimile/Internet/Printer control panel functions.

 

 

(Refer to page 13 for details on the Original Size/Copy Size Keys.)

10

Image 10 Contents
DP-2000 EnglishOperation Chart Common Features and UsageEnergy Star Table of Contents Options Problem SolvingOthers For Your Safety PrecautionsLaser Safety Precautions Handling Toner and Paper VentilationInstallation FCC Warning For U.S.AControl Panel Clear Keys Contents Refer to Function KeyReset Key Stop KeyMargin Key Contents Refer to Book KeyEdge Key Cursor KeysBasic Copy Full Size CopyingSelect the Copy Copying with Preset RatiosReduction or Enlargement Copying SizeZoom Zoom CopyingPress Cursor F or G keys to select Zoom Ratio Copying on Special Paper, etc Using the Sheet Bypass$Adjust the side guides # Place approximately 50 sheets of paper into the trayKey Operation Sided/Original H Copy Duplex CopySided/1-Sided Copy Book \Press 2-Sided Procedure\ 2/2 \ 1/2 \ 2 Copy Sided Copy keyBook \ 2 Copy Book \ 2 CopyPlace the Original on the Platen Platen1 key 1 CopyPress 1 CopyPlace Press Originals CopyKey Press Book, Edge or MarginBook/Edge/Margin Margin keyOHP Interleaving OHP InterleavingPress the Copied key or the Blank key Blank PaperTo store a job in memory To recall a job stored in memorySleep Mode Energy Saver/Interrupt ModeEnergy Saver Mode Interrupt ModeSetting the Digital Skyshot Mode Skyshot ModeProceed as Follows Setting the Manual Skyshot Mode Press the Function Key Copying with the Manual Skyshot ModeSet Manual Skyshot mode first Platen Upper- left corner Copy Combined Function TableSort SIDED/ORIGOptions Using Function Modes to Change the Initial Copy ModesFunction Input Identification CodeModes Function Initial Setting General FunctionsCopier Settings General Functions for Key Operator Copier Settings for Key Operator Function Setting Changing the Auto Exposure SettingFunction Setting for Key Operator Changing the Paper SizePaper Guide a Stopper Guide b Departmental Counter Counter 6 digits Accessories ComponentsADF DA-AS200/i-ADF DA-AR250 FeaturesAutomatic Document Feeder ComponentsOriginal OperationPlace Inappropriate originalsPlaten Face-Up Finisher/Exit Guide UnitDA-FS200 Finisher Press Sort/Finish keyReplacing the staple cartridge Pull out the tapeReinstall the staple cartridge #Open the staple cover Adding Paper J Problem SolvingSheet Paper Tray Slowly pull the waste toner box Replacing the Toner Cartridge and Waste Toner Box ?Open the front cover Straight outShake the new toner cartridge Install the new toner cartridge intoInstall a new waste toner box WellRemoving a Misfeed Paper Misfeed IndicatorPaper Misfeed Locations Finisher Removing a Misfed Paper Paper Transport AreaPaper Entry Area Open the right coverAutomatic Duplex Unit ADU Close the right coverSystem Console ADF/i-ADF #Lift up the ADF Input Tray Check TroubleshootingBefore Calling Service ActionMarked Copies As a rule, clean weeklyLight Copies Platen CoverBattery Replacement Required Message Replacing the BatteryBattery Replacement Procedure Specifications DP-2000 CopierBin Finisher DA-FS200 ADF DA-AS200, i-ADF DA-AR2502nd/3rd/4th Paper Feed Module DA-DS210/DA-DS200 Options and Supplies Part Name RemarksFor Fax For PrinterWarranty