Panasonic DP-200 manual Problem Solving, Adding Paper J, Sheet Paper Tray

Page 45

Problem Solving

Adding Paper (J)

■550-Sheet Paper Tray

1

Pull the paper tray out of the copier.

2

Place the paper with the copying

surface facing upward.

Special papers, like glossy paper, mailing

labels and transparencies cannot be used

 

in the paper tray. Use the sheet bypass

3

for special paper.

Make sure paper is not loaded

 

 

above the overfill indicator located

 

in the paper tray.

4

Firmly push the paper tray back

 

 

into the copier.

ATTENTION

CDo not use paper with folds or wrinkles.

Refer to page 34 for details on changing the paper size for the paper tray.

 

CUnused paper should always be placed into a bag and the opening should be sealed for storage.

If the paper is left exposed, problems such as paper curl, paper jams, wrinkles or loss of copied image quality may occur.

Options

J

45

Page 44 Page 46
Image 45
Page 44 Page 46
Contents English DP-2000Common Features and Usage Operation ChartEnergy Star Table of Contents Problem Solving OptionsOthers Precautions For Your SafetyLaser Safety Handling Toner and Paper Ventilation PrecautionsFCC Warning For U.S.A InstallationControl Panel Reset Key Contents Refer to Function KeyClear Keys Stop KeyEdge Key Contents Refer to Book KeyMargin Key Cursor KeysFull Size Copying Basic CopyReduction or Enlargement Copying Copying with Preset RatiosSelect the Copy SizeZoom Copying ZoomPress Cursor F or G keys to select Zoom Ratio $Adjust the side guides Using the Sheet BypassCopying on Special Paper, etc # Place approximately 50 sheets of paper into the traySided/1-Sided Copy Sided/Original H Copy Duplex CopyKey Operation Book \\ 2/2 \ 1/2 \ 2 Copy ProcedurePress 2-Sided Sided Copy keyPlace the Original on the Platen Book \ 2 CopyBook \ 2 Copy PlatenPress 1 Copy1 key 1 CopyCopy Place Press OriginalsKey Book/Edge/Margin MarginPress Book, Edge or Margin keyPress the Copied key or the Blank key OHP InterleavingOHP Interleaving Blank PaperTo recall a job stored in memory To store a job in memoryEnergy Saver Mode Energy Saver/Interrupt ModeSleep Mode Interrupt ModeSkyshot Mode Setting the Digital Skyshot ModeProceed as Follows Copying with the Manual Skyshot Mode Setting the Manual Skyshot Mode Press the Function KeySet Manual Skyshot mode first Platen Upper- left corner Sort Combined Function TableCopy SIDED/ORIGFunction Using Function Modes to Change the Initial Copy ModesOptions Input Identification CodeGeneral Functions Modes Function Initial SettingCopier Settings General Functions for Key Operator Copier Settings for Key Operator Changing the Auto Exposure Setting Function SettingChanging the Paper Size Function Setting for Key OperatorPaper Guide a Stopper Guide b Departmental Counter Counter 6 digits Components AccessoriesAutomatic Document Feeder FeaturesADF DA-AS200/i-ADF DA-AR250 ComponentsPlace OperationOriginal Inappropriate originalsDA-FS200 Finisher Finisher/Exit Guide UnitPlaten Face-Up Press Sort/Finish keyPull out the tape Replacing the staple cartridgeReinstall the staple cartridge #Open the staple cover Problem Solving Adding Paper JSheet Paper Tray Open the front cover Replacing the Toner Cartridge and Waste Toner Box ?Slowly pull the waste toner box Straight outInstall a new waste toner box Install the new toner cartridge intoShake the new toner cartridge WellMisfeed Indicator Removing a Misfeed PaperPaper Misfeed Locations Finisher Paper Transport Area Removing a Misfed PaperOpen the right cover Paper Entry AreaClose the right cover Automatic Duplex Unit ADUSystem Console ADF/i-ADF #Lift up the ADF Input Tray Before Calling Service TroubleshootingCheck ActionLight Copies As a rule, clean weeklyMarked Copies Platen CoverReplacing the Battery Battery Replacement Required MessageBattery Replacement Procedure DP-2000 Copier SpecificationsADF DA-AS200, i-ADF DA-AR250 Bin Finisher DA-FS2002nd/3rd/4th Paper Feed Module DA-DS210/DA-DS200 Part Name Remarks Options and SuppliesFor Printer For FaxWarranty
Top Page Image Contents