Panasonic DP-200 manual Replacing the staple cartridge, Pull out the tape

Page 42

Accessories

Finisher/Exit Guide Unit

3. Replacing the staple cartridge

ADD STAPLES

U11

The message shown on the left appears when the staples run out.

1

Hold the latch and pull out the finisher.

2

Remove the staple cartridge.

 

3

#Remove the empty staple case.

 

 

$Install the new staple case.

4

Pull out the tape.

 

42

Page 41 Page 43
Image 42
Page 41 Page 43
Contents DP-2000 EnglishOperation Chart Common Features and UsageEnergy Star Table of Contents Problem Solving OptionsOthers Precautions For Your SafetyLaser Safety Precautions Handling Toner and Paper VentilationInstallation FCC Warning For U.S.AControl Panel Clear Keys Contents Refer to Function KeyReset Key Stop KeyMargin Key Contents Refer to Book KeyEdge Key Cursor KeysBasic Copy Full Size CopyingSelect the Copy Copying with Preset RatiosReduction or Enlargement Copying SizeZoom Copying ZoomPress Cursor F or G keys to select Zoom Ratio Copying on Special Paper, etc Using the Sheet Bypass$Adjust the side guides # Place approximately 50 sheets of paper into the trayKey Operation Sided/Original H Copy Duplex CopySided/1-Sided Copy Book \Press 2-Sided Procedure\ 2/2 \ 1/2 \ 2 Copy Sided Copy keyBook \ 2 Copy Book \ 2 CopyPlace the Original on the Platen Platen1 key 1 CopyPress 1 CopyCopy Place Press OriginalsKey Press Book, Edge or MarginBook/Edge/Margin Margin keyOHP Interleaving OHP InterleavingPress the Copied key or the Blank key Blank PaperTo store a job in memory To recall a job stored in memorySleep Mode Energy Saver/Interrupt ModeEnergy Saver Mode Interrupt ModeSkyshot Mode Setting the Digital Skyshot ModeProceed as Follows Copying with the Manual Skyshot Mode Setting the Manual Skyshot Mode Press the Function KeySet Manual Skyshot mode first Platen Upper- left corner Copy Combined Function TableSort SIDED/ORIGOptions Using Function Modes to Change the Initial Copy ModesFunction Input Identification CodeModes Function Initial Setting General FunctionsCopier Settings General Functions for Key Operator Copier Settings for Key Operator Function Setting Changing the Auto Exposure SettingFunction Setting for Key Operator Changing the Paper SizePaper Guide a Stopper Guide b Departmental Counter Counter 6 digits Accessories ComponentsADF DA-AS200/i-ADF DA-AR250 FeaturesAutomatic Document Feeder ComponentsOriginal OperationPlace Inappropriate originalsPlaten Face-Up Finisher/Exit Guide UnitDA-FS200 Finisher Press Sort/Finish keyReplacing the staple cartridge Pull out the tapeReinstall the staple cartridge #Open the staple cover Problem Solving Adding Paper JSheet Paper Tray Slowly pull the waste toner box Replacing the Toner Cartridge and Waste Toner Box ?Open the front cover Straight outShake the new toner cartridge Install the new toner cartridge intoInstall a new waste toner box WellMisfeed Indicator Removing a Misfeed PaperPaper Misfeed Locations Finisher Removing a Misfed Paper Paper Transport AreaPaper Entry Area Open the right coverAutomatic Duplex Unit ADU Close the right coverSystem Console ADF/i-ADF #Lift up the ADF Input Tray Check TroubleshootingBefore Calling Service ActionMarked Copies As a rule, clean weeklyLight Copies Platen CoverReplacing the Battery Battery Replacement Required MessageBattery Replacement Procedure Specifications DP-2000 CopierADF DA-AS200, i-ADF DA-AR250 Bin Finisher DA-FS2002nd/3rd/4th Paper Feed Module DA-DS210/DA-DS200 Options and Supplies Part Name RemarksFor Fax For PrinterWarranty
Top Page Image Contents