Panasonic DP-200 manual #Open the staple cover

Page 44

Accessories

Finisher/Exit Guide Unit

4. If the unit fails to staple after replacing the staple cartridge, follow the instructions below.

1	Remove the staple cartridge.
	Remove the staple cartridge.
2	#Open the staple cover.
	#Open the staple cover.
	$Remove the residual staple.
	%Close the staple cover.

3	Reinstall the staple cartridge.

44

Image 44

Contents DP-2000 EnglishOperation Chart Common Features and UsageEnergy Star Table of Contents Others Problem SolvingOptions Laser Safety PrecautionsFor Your Safety Precautions Handling Toner and Paper VentilationInstallation FCC Warning For U.S.AControl Panel Contents Refer to Function Key Reset KeyClear Keys Stop KeyContents Refer to Book Key Edge KeyMargin Key Cursor KeysBasic Copy Full Size CopyingCopying with Preset Ratios Reduction or Enlargement CopyingSelect the Copy SizePress Cursor F or G keys to select Zoom Ratio Zoom CopyingZoom Using the Sheet Bypass $Adjust the side guidesCopying on Special Paper, etc # Place approximately 50 sheets of paper into the traySided/Original H Copy Duplex Copy Sided/1-Sided CopyKey Operation Book \Procedure \ 2/2 \ 1/2 \ 2 CopyPress 2-Sided Sided Copy keyBook \ 2 Copy Place the Original on the PlatenBook \ 2 Copy Platen1 Copy Press1 key 1 CopyKey CopyPlace Press Originals Margin Book/Edge/MarginPress Book, Edge or Margin keyOHP Interleaving Press the Copied key or the Blank keyOHP Interleaving Blank PaperTo store a job in memory To recall a job stored in memoryEnergy Saver/Interrupt Mode Energy Saver ModeSleep Mode Interrupt ModeProceed as Follows Skyshot ModeSetting the Digital Skyshot Mode Set Manual Skyshot mode first Platen Upper- left corner Copying with the Manual Skyshot ModeSetting the Manual Skyshot Mode Press the Function Key Combined Function Table SortCopy SIDED/ORIGUsing Function Modes to Change the Initial Copy Modes FunctionOptions Input Identification CodeModes Function Initial Setting General FunctionsCopier Settings General Functions for Key Operator Copier Settings for Key Operator Function Setting Changing the Auto Exposure SettingFunction Setting for Key Operator Changing the Paper SizePaper Guide a Stopper Guide b Departmental Counter Counter 6 digits Accessories ComponentsFeatures Automatic Document FeederADF DA-AS200/i-ADF DA-AR250 ComponentsOperation PlaceOriginal Inappropriate originalsFinisher/Exit Guide Unit DA-FS200 FinisherPlaten Face-Up Press Sort/Finish keyReplacing the staple cartridge Pull out the tapeReinstall the staple cartridge #Open the staple cover Sheet Paper Tray Problem SolvingAdding Paper J Replacing the Toner Cartridge and Waste Toner Box ? Open the front coverSlowly pull the waste toner box Straight outInstall the new toner cartridge into Install a new waste toner boxShake the new toner cartridge WellPaper Misfeed Locations Misfeed IndicatorRemoving a Misfeed Paper Finisher Removing a Misfed Paper Paper Transport AreaPaper Entry Area Open the right coverAutomatic Duplex Unit ADU Close the right coverSystem Console ADF/i-ADF #Lift up the ADF Input Tray Troubleshooting Before Calling ServiceCheck ActionAs a rule, clean weekly Light CopiesMarked Copies Platen CoverBattery Replacement Procedure Replacing the BatteryBattery Replacement Required Message Specifications DP-2000 Copier2nd/3rd/4th Paper Feed Module DA-DS210/DA-DS200 ADF DA-AS200, i-ADF DA-AR250Bin Finisher DA-FS200 Options and Supplies Part Name RemarksFor Fax For PrinterWarranty