Useful Information
Handling and Maintenance
Computrace® Software
Computrace® software tracks your stolen computer.
Perform the following steps before installing Computrace® software.
Computrace® software is not included or installed in this computer.
CAUTION
You will be unable to set [Computrace (R) BIOS Module] to [Disable] once you have set to [Enable]. Do not change the setting when not used.
Even if you have set [Computrace (R) BIOS Module] to [Enable], this setting may return to [Disable] after repairs to the motherboard, etc. have been made.
NOTE
Consult Absolute Software Corp. before disposal.
Refer to the following URL for Computrace® software for installation and available service regions. Note that this service is only available in certain regions.
http://www.absolute.com
1 Turn on or restart the computer, and press F2 while [Panasonic] boot screen is dis- played.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
2Select the [Security] menu, then select [Computrace (R)
3Select [Computrace (R) BIOS Module], and set to [Enable].
4At the confirmation message, select [Execute] and press Enter.
5At the reconfirmation message, select [Execute] and press Enter.
6Press F10 .
At the confirmation message, select [Yes] and press Enter.
The computer restarts.
Maintenance
To clean the LCD panel
<Only for model with touchscreen>
Use the soft cloth included with the computer. (For further information, refer to “Suggestions About Cleaning the LCD Surface” that comes with the soft cloth.)
<Only for model without touchscreen> Wipe with a soft dry cloth such as gauze.
To clean areas other than the LCD panel
Wipe with a soft dry cloth such as gauze. When using detergent, dip a soft cloth in
CAUTION
Do not use benzene, thinner, or rubbing alcohol since it may adversely affect the surface causing discoloration, etc. Do not use
Do not apply water or detergent directly to the computer, since liquid may enter inside of the computer and cause malfunction or damage.
18