Panasonic CF-30 First-time Operation, Connect your computer to a power outlet, Setup Windows

Page 14

First-time Operation

2

Started

3

 

Getting

2

 

 

1

 

3

2 Connect your computer to a power outlet.

The battery charging starts automatically.

CAUTION

Do not disconnect the AC adaptor and do not switch the wireless switch to on until the first-time operation procedure is completed.

When using the computer for the first time, do not connect any peripheral device except the battery pack and AC adaptor.

Handling the AC adaptor

Problems such as sudden voltage drops may arise during periods of thunder and lightning. Since this could adversely affect your computer, an uninter- ruptible power source (UPS) is highly recommended unless running from the battery pack alone.

3 Turn on the computer.

APull the carrying handle forward.

BPush and hold the latch (A), and lift open the display.

CSlide and hold the power switch for approximately one second until the power indicator lights.

CAUTION

Do not slide the power switch repeatedly.

The computer will forcibly be turned off if you slide and hold the power switch for four seconds or longer.

Once you turn off the computer, wait for ten seconds or more before you turn on the computer again.

Do not perform the following operation until the hard disk drive indicator turns off. Connecting or disconnecting the AC adaptor

Sliding the power switch

Touching the keyboard, touch pad or touchscreen (only for model with touchscreen) Closing the display

When the CPU temperature is high, the computer may not start up to prevent overheating of the CPU. Wait until the computer cools down, and then turn the power on again. If the computer does not power on even after cooling down, contact Panasonic Technical Support ( page 36).

4 Setup Windows.

AFollow the on-screen instructions.

CAUTION

When you set date/time/time zone and click [Next], the screen may not go to the next step for a few minutes. Do not touch the keyboard or touch pad, and wait until the screen changes.

If “An unexpected error has occurred…” (or a similar message) is displayed, click [OK]. This is not a malfunction.

Wait until the hard disk drive indicator has turned off.

This computer periodically records the management information including the hard disk information such as number of hours powered-on, number of times powered-on, internal temperature, replacement sector. The maximum data vol- ume for each record is 750 byte. These information are only used for estimating the cause when the hard disk goes down by any possibility. They are never sent to outside via network nor used for any other purpose except for the purpose described the above.

To disable the function, add the check mark for [Disable the automatic save function for management information history] in [Hard Disk Status] of PC Infor- mation Viewer, and click [OK].

14

Image 14
Contents Contents Personal ComputerCopyright Disclaimer Trademarks IntroductionTerms and illustrations in these instructions Read Me First Models for U.S.AIndustry Canada IC Notice for modem Read Me FirstModels for Canada Industry Canada Models for EuropeCanadian ICES-003 RF Exposure WarningLithium Battery / Pile au lithium Information to the UserPrecautions Do Not Use with Any Other Computer Precautions Battery PackDo Not Turn the Volume Up to Loud When Using Head- phones 35-M-1 Description of Parts Ext Antenna Connector Expansion Bus Connector SD Memory Card Indicator Blinking During accessIeee 1394 Interface Connector Right sideDescription of Parts First-time Operation Insert the battery packAC Cord Battery Pack Operating Instructions This bookFirst-time Operation Connect your computer to a power outletSetup Windows Turn on the computerRegarding Windows XP Windows UpdateCreate a new account On-screen Manual To access the Reference ManualTo access the Important Tips Reference ManualOperation environment Handling and MaintenanceWhen using peripheral devices Handling cautionsTo clean the LCD panel Handling and MaintenanceMaintenance To clean areas other than the LCD panelClick Next Hard Disk Backup Function Recover ProInstallation PreparationComplete Restore Hard Disk Backup Function Recover ProComplete Backup Press Space Hard Disk Data Erase UtilityPress 2 to execute 2. Erase HDD Reinstalling Software Perform the first-time operation Turn the computer off by using the power switchPress Error Code/Message Troubleshooting Basic Starting UpShutting down Troubleshooting BasicEntering Password DisplayFn + F2 Touch Pad / Touchscreen only for model with touchscreenRecover Pro OthersHardware Diagnostics Regarding the PC-Diagnostic UtilityConnect the AC adaptor and turn on the wireless switch. Hardware DiagnosticsRunning the Diagnostic Check Press While Panasonic boot screen is displayedTroubleshooting Limited USE License Agreement About Intel software productsTermes, clauses et conditions Contrat de licence d’usage limitéLicence Specifications Main SpecificationsWireless LAN Only for model with wireless LAN BluetoothTM Only for model with BluetoothSpecifications For U.S.A Limits and ExclusionsLimited Warranty For CanadaMemo Panasonic Computer Solutions Company Panasonic Canada Inc