Panasonic CF-30 appendix Hardware Diagnostics, Running the Diagnostic Check

Troubleshooting

Hardware Diagnostics

We recommend that you use the touch pad for operations. When not using the touch pad, you can operate using the internal keyboard instead.

Operations	Touch pad operations	Internal keyboard operations
Select icon	Place the cursor above the icon		Press				, and then press
				Space
				( (close) cannot be selected)
Click the icon	Tap or click (right click cannot be used)		Press				above the icon
				Space
Complete the PC- Diagnos-	Click (close)		Press		+			+		.
				Ctrl		Alt			Del
tics Utility and then restart
the computer

By clicking the icon, you can execute the following operations:

: Start the diagnostic check from the beginning

: Stop the diagnostic check (You cannot restart the check partway through by clicking )

: Display help (click the screen or press Space to return to the original diagnostic check screen)

Running the Diagnostic Check

Disconnect any peripheral devices (e.g., storage device) before running the diagnostic check.

1	Connect the AC adaptor and turn on the wireless switch. ( page 10)
	During the diagnostic check, do not remove the AC adaptor, or attach any peripheral devices.
2	Turn on or restart the computer, and press									for several times while [Panasonic] boot
									F2
	screen is displayed.
	The Setup Utility starts up.
	If the password is requested, enter the Supervisor Password.
	If you are using the computer after changing the settings from the status at the time of purchase, we recom-
	mend that you make a note of the settings that are changed.
3	Press		.
		F9
	At the confirmation message, select [Yes] and press										.
								Enter
4	Press			.
		F10
	At the confirmation message, select [Yes] and press							Enter			.
	The computer will restart.
5	Press				+		while [Panasonic] boot screen is displayed.
		Ctrl				F7
	When the PC-Diagnostic Utility starts up, it will automatically begin the diagnostic check for all hardware compo-
	nents.
	If the password is requested, enter the password.

The touch pad and the internal keyboard cannot be used until alternating blue and yellow colors are dis- played on the left side of the hardware icon ( page 29). If the touch pad does not operate properly, press

Ctrl+Alt +Del to restart the computer, or slide the power switch to turn the power off, and then restart the PC-Diagnostic Utility.

NOTE

Using the following procedure, you can run a diagnostic check on a specified hardware component, or run an extended diagnostic check on the hard disk.

AClick to stop the diagnostic check.

BClick the icon for the hardware that is not to be checked, so that the icon is displayed in gray (B). When running a check on the hard disk, clicking the icon once will turn on the extended diagnostic check (“FULL” (C) will be displayed below the icon); click again, and the icon will be displayed in gray.

CClick to start the diagnostic check. C

30