Panasonic CF-30KTPAXxM Setting the Antenna PCB L and R, Arranging the Antenna L and R Cables

9.2.Reassembly Instructions

9.2.1.Attention when CF-30 series is repaired

•Please execute writing BIOS ID when you exchange the Main Board.

•Parts (Sheet and rubber) etc. related various the Conductive Cloth and Heat Spreader cannot be recycled. Use new parts.

9.2.2.Setting the Antenna PCB L and R

1.Set the Antenna PCB L and R using the 2 Screws <N2>.

2.Fix the W-LAN ANT Cover L and R using the 4 Screws <N2> (No1 to No2).

Note:

Tighten the Screws in the numbered order (No1 to No4).

Screws <N2>: DRHM5054XA

LCD Rear Cabinet Ass’y

W-LAN ANT Cover L

Antenna PCB L

<N2>

<N2>

<N2>

<N2>	<N2>
<N2>	Antenna PCB R

W-LAN ANT Cover R

■Arranging the Antenna L and R Cables

Torque of tightening screw :0.45– 0.05N•m( 4.5 – 0.5kgf•cm)

Insert the cable between the pins.	Insert the cable between the pins.
X	X

LCD Rear ASS’Y

Put it along the inside of boss on X part

Safety Working

CAUTION	S1:Insulation S2:Bitten S3:Sharp Edge
	S4:Part No. Check S5:Other

X

X

X

S2	Do not pinch the cable
	out of the cabinet

Rear Cable Sheet L

Coming off the tape is arrowed

Attach it fitting to the corner

Cable color : Black

Match it to the protrusion side and attach it between the bosses.

	S2	Do not pinch the cable
X		out of the cabinet
	Rear Cable Sheet R
X	Cable color : Gray
	Rear Screw Sheet

Match it to the concave

Xside and attach it between

the bosses.

Tape	S2	Do not pinch the cable
		out of the cabinet

Tighten the screw Place the anntena main Place the anntena sub Tighten the screw

9-11