Panasonic CF-30KTPAXxM Push and bend Attach it to HDD closely not to loosen, HDD Cushion Black

* Notes:

1.Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2

S2	Do not place the damper
	over the plate of FPC.
HDD Damper Ass’y
Make sure the product
with black sheet on the
yellow sponge.		Fold the FPC from the board edge.
	HDD Ass’y	HDD Set Insert after removing the
		Release Paper of the two-sided tape.

Remove the Release Paper on the back, close and attach it.

S2

Do not place the damper over the plate of heater.

Push and bend

Attach it to HDD closely not to loosen.

CAUTION

S1:Insulation S2:Bitten S3:Sharp Edge S4:Part No. Check S5:Other

*Notes:

1.Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2

When attaching HDD Cushion (Yellow) and HDD Cushion (Black), set the bending part of the metal plate up.

HDD Thermal Plate

Do not bend it at a sharp angle to put natural R.

1~3	0~1	1~3
1~3		1~3
1~2		HDD Cushion (Black)
		Metal Plate

(15)

To the level of attaching closely in this range

Longer Direction

Attach the HDD Cushion (Yelllow)

	Attach the
	HDD Cushion
Attach the	(Yelllow)
HDD Cushion
(Black)	Attach the HDD
Sheet	Thermal Plate

0–1

Prepare the metal plate bend.

9-38