Panasonic CF-30KTPAXxM service manual Preparations LCD Cable, Assembly of LCD Unit

■ Preparations LCD Cable

Put the pin side to the upper side.

Put the Connector bottom in the rib on the jig.

LCD cable Connect

Attach the sheet matching to the upper right.

LCD CABLE

WP SHEET Attach.

Fit to the Moran edge and avoid running over. The Cables should not be overlapped.

PET tapeWrap

Finish

Set the LCD signal Cable on the

left guidegroove.

Set the 6-conductor Cable on the right guide groove.

Set the 13-conductor Cable on the center guide groove.

Remove the left Release Paper, and attach it putting 13-conductor Cable inside.

Leave the left Release Paper without removing.

Remove the Release Paper and set the Cable on it.

Pass it under the

13-conductor Cable and attach it.

			From the sheet end
	Non T/S model only
			24mm		2
		(19)		Bundle all the
				LCD Cables.
PET tapeWrap

■Assembly of LCD Unit

* Notes:

1. Apply the load when attaching the parts. 20N to 30N (2 to 3Kgf)/cm2

Confirm that the LCD Cushion is not wrapped.

Attach the Inverter MIL Shierd

Match to the LCD edge and attach it.

Clearance : 2 mm or less

0 0.5mm

LCD Drop Holder Insertion

LCD Front Ass’y

LCD Drop Holder Insertion

9-13