Panasonic CF-30KTPAXxM service manual HDD Guide, FPC Cushion, FPC FIG1

					1. Set HDD GUIDE and fix with Screw.
CAUTION	S1:Insulation S2:Bitten S3:Sharp Edge				2. Fix with Screw.
	S4:Part No. Check S5:Other				3. Apply tetra coating to each Connector pin.
					Battery Connector : Set the nozzle tip apart from the Connector with
						1 to 10 mm and spray from the Connector end
Torque of tightening screw :0.19 ± 0.02N·m( 2.0 ± 0.2kgf·cm)
						to the end for about 1 minute. Do the same to
			Screw			the opposite direction.
			Tighten		HDD Connector : Set the nozzle tip apart from the Connector with 1
View from A						to 10 mm and spray from the Connector end to the
direction						end one way for about 1 minute.
				FPC HDD BATT Set	(Refer to M14 in "Common Assembly Instruction Manual".)
							View from B
							direction
	㪘	Do not fold.
								Battery Connector

㪙
			㪚	View from C
BATT HDD CN	HDD GUIDE			direction	HDD Connector
ANGLE Set	Set	This Connector does not need tetra coating.

Note for attaching the Flex to the metal.

Insert so that the
stiffening plate side	Screw-1	Screw-2
touches.	Tighten	Tighten
Correct operation	Wrong operation

Valley Fold (Dotted line) Mountain Fold (Full line)

Valley Fold (Dotted line)

Mountain Fold (Full line)

Insert plug into socket	FPC insertion guidline
	Ensure the FPC edge is
A	at the steel plate edge.
	(Misalignment: 0.5 or less)
Cable
Match the hook of	Relay circuit board Assy
Connector lock to the center.
Insert FPC into Relay
circuit board Assy's socket

	Reference
FPC CUSHION	1.5mm

Valley Fold (Dotted line)

Fold along the level of the outer shape.

After folding

The terminal of the antenna cable must not come in

contact with this terminal.

(Put it on the metal fittings side. )

Figure seen from direction of arrow of A

The attention of folding :Breakage countermeasure.

1. The bending inside is R0. 5~1 FIG1

2.Don't mistake a bending direction. Don't use a mistaken thing.

Lock after inserting FPC. Lock FPC

FPC

FIG1

FPC

䌏䌋

(R0.5~1)

䌎䌇

9-29