6.2.Disassembly
6.2.1.Preparation
Attention:
Before disassembly, be sure to perform the following steps.
1.End the Windows.
2.Turn off the power and then remove the AC adaptor.
3.Slide the hooks (A) and then remove the battery pack.
4.Remove the screw (A) and then remove the DIMM cover. (Remove if the DIMM memory is equipped with)
Screw (A) : XSB2+4FNL(N16)
Baattrey Pack
Hook(A)
Screw(A)
DIMM Cover
6.2.2.Removing the Keyboard
Preparation : perform the section 6.2.1. first.
1.Remove the 4 screws (B). Screw(B):DXQT2+E12FNL(N11)
2.Remove the 2 keyboard hook plates, and then remove the hook of back side of keyboard with screw driver.
Screw(B) | Keyboard Hook Plate |
Screw(B)
Screw(B)
Keyboard Hook Plate
3.The LCD unit is opened up to about 90° by operating the LCD knob.
4.Remove the 6 hooks (B).
5.Open the keyboard from LCD side and then turn it inside out on the top case.
Note:
It can remove with the keyboard hook plate.
LCD Unit | Hook(B) |
LCD Knob | Hook(B) |
6.Remove the heat spreader from buttom of the keyboard.
7.Remove the keyboard FFC from the connector (CN15) and then remove the keyboard.
Heat Spreader
KeyBoard
CN15
28