Panasonic CF-T4HWETZBM service manual Putting of tape

2.Attachment preparation of Key Board 2-1. Putting of Heat Sheet KB Large

Inclination is set to 0.5mm or less.

Touch the KB hole

Inclination is set to 0.5mm or less.

Touch the KB hole

2-2. Putting of tape

0	0.5mm
0.5	1.5mm	0	1mm	8	1mm	0	1mm	0.5	1.5mm

Tape(KBD)(KBD)

KeyBoard exterior and FPC are parallel.

3.Screw tightening of bottom case (1)

The keyboard is inserted, and after the keyboard hooks are inserted in order of a and b while holding the keyboard, the screw tightening is done in the following order.

Note:The sheet metal must not run aground on the rib (Refer to the figure below). 2-1. DXHM0039ZA(D:N5) is tightened. No.1 to No.7

2-2. DXHM0057ZA(G:N7) is tightened. No.8 to No.12

Screw(G)	Screw(D)	Keyboard Hook b
	Screw(D)	Screw(D)
Screw(D)		Screw(D)
Screw(D)
Screw(D)		Keyboard Hook a
			Keyboard	OK
Screw(G)			Hook	Top Case Rib
				Top Case
				NG
Screw(G)
Screw(G)		Screw(G)	Assembly reference chart

41