Panasonic PT-D5600E manual Example of connecting with AV products, Example of connecting with PCs

Example of connecting with AV products

DVD player	Video deck	DVD player
		Digital Hi-vision video deck
		with DVI/HDMI terminal

									DVI-D Cable or HDMI-DVI
									conversion cable
		R/PR	G/Y	B/PB	SYNC/HD	VD			(available in the market)
VIDEO IN	S-VIDEO IN			RGB 1 IN			RGB 2 IN	DVI-D IN	LAN
	REMOTE 1		REMOTE 2		IN	SERIAL	OUT
	IN	OUT							Control PC

Red (Connect PR)	D-SUB 9-pin straight cable
Blue (Connect PB)

Green(Connect Y)

Digital Hi-vision video deck

Attention • When connecting with a video deck, be sure to use the one with a built-in time base corrector (TBC) or use a TBC between the projector and the video deck.

•If nonstandard burst signals are connected, the image may be distorted. If this is the case, connect a TBC between the projector and the video deck.

•The EDID settings suited to the equipment connected must be performed when DVI-D signals are input. (Refer to page 33.)

ENGLISH

Example of connecting with PCs

PC	PC with
	DVI-D terminal

PC

Control PC

DVI-D Cable (available in the market)

		R/PR	G/Y	B/PB	SYNC/HD	VD
VIDEO IN	S-VIDEO IN			RGB 1 IN			RGB 2 IN	DVI-D IN	LAN
	REMOTE 1		REMOTE 2		IN	SERIAL	OUT
	IN	OUT

		R/PR	G/Y	B/PB	SYNC/HD	VD
VIDEO IN	S-VIDEO IN			RGB 1 IN			RGB 2 IN	DVI-D IN	LAN
	REMOTE 1		REMOTE 2		IN	SERIAL	OUT
	IN	OUT

Note • For the specifications of the RGB signals that can be applied from the PC, see the data sheet on page 58.

•If your PC has the resume feature (last memory), the computer may not function properly until the resume capability is disabled.

•When the SYNC ON GREEN signal is input, do not input sync signals to the SYNC/HD and VD terminals. Doing so may disrupt the images since, rather than using synchronization initiated by the GREEN signal, the sync signals of the SYNC/HD and VD terminals will be used instead. Even if the images are not disrupted, the white balance may be lost. If this is the case, select “USER” as the “COLOR TEMP.” setting (see page 28), and adjust “W-BAL LOW”.

•The white balance may be lost when the SYNC ON RGB signal is input. If this is the case, select “USER” as the “COLOR TEMP.” setting (see page 28), and adjust “W-BAL LOW”.

•The EDID settings suited to the equipment connected must be performed when DVI-D signals are input. (Refer to page 33.)

21