Panasonic PT-DW5000EL, PT-DW5000E, PT-D5600EL manual Projection, Powering up the projector

Projection
R/PR G/Y B/PB		SYNC/HD VD
VIDEO IN S-VIDEO IN	RGB 1 IN
REMOTE 1	REMOTE 2	IN	SE
IN OUT

Powering up the projector

When using an optional lens, install a projection lens before powering up the projector. (Refer to page 24.)

Remove the lens cover beforehand.

Connect the supplied power cable. (220-240 V AC, 50 Hz/60 Hz)

Press the “ I ” marked side of the MAIN POWER switch to turn on the power.

The power indicator lights up red, and the projector is placed in the standby mode.

Press the “ I ” button. [on the main unit or the remote control]

The power indicator illuminates in green and soon the image is projected on the screen.

Making adjustment and selection

Press the LENS button three times to adjust the lens shift. (Refer to page 24.)

Press the AUTO SETUP button if the input signal is RGB/DVI signal. (Refer to page 25.) [on the main unit or the remote control]

Fit the image size to the screen size.

Press the LENS button twice and adjust the zoom of the lens on the lens zoom adjustment menu.

Press the LENS button and adjust the focus of the lens on the lens focus adjustment menu.

Display the zoom adjustment menu again and adjust the zoom of the lens to fit the image size to the screen size. (Refer to page 24.)

Roughly adjust the focus of the lens.		Note • If the projector is powered up at about 0 ˚C,
(Refer to page 24.)		a warm-up period of approximately five
Press the LENS button on the main unit or the		minutes may be necessary to start
		projection.
remote control unit to display a focus adjustment
		The temperature monitor (TEMP) lights
screen. Pressing	buttons to adjust the
		during the warm-up period.
image into focus.
		When the warm-up is completed, the
Select and set the projection scheme.
		temperature monitor (TEMP) turns off and
(Refer to page 34.)		the image is projected on the screen.
Select the input signal by pressing the		• If the surrounding temperature is very low
		and the warm-up period exceeds five
input selector button to toggle through		minutes, the control determines it as an
RGB1, RGB2, VIDEO, S-VIDEO and DVI.		abnormal condition and turns off the
[on the main unit or the remote control]		power automatically. If this happens, raise
Turn the feet, and adjust the tilt of the		the surrounding temperature to 0 °C or
		higher and then turn the main power “on”
main unit in the front and rear or left		and turn the power “on” ( ).
and right.		• It is recommended that the projector be
Use the lens left/right adjustment dial to		allowed to warm up for at least 30 minutes
		before any adjustments are made to the
adjust the direction of the lens. (page 24)		focus.

22