Turning off the power
#, $POWER button
POWER INPUT | MENU |
ENTER
AUTO
SETUP
STD
SHUTTER
RETURN 
ENTERVOLUME
ROTATE
Direct power off function
You can disconnect the mains lead during projection or immediately after use and move the projector. The cooling fan will operate by the internal power supply to cool down the lamp.
B When this function is used, it may take more time for the lamp to turn back |
on again compared to when the lamp cools down with the mains lead |
% Mains lead
#Press the POWER button.
BThe “POWER OFF” confirmation screen will be displayed.
POWER OFF [POWER] OK
connected. |
B Do not put the projector in the softcase while the POWER button on the |
projector is illuminated. |
NOTE:
BDo not disconnect the mains lead while the files in the SD memory card are being played back.
CAUTION
If not using the projector for an extended period of time, disconnect the mains plug from the mains socket.
B If dust builds up on the mains plug, the resulting humidity may damage the |
insulation, which could result in fire. |
B This projector continues to draw approximately 3 W of power even when |
Basic operation
$Press the POWER button again.
BThe lamp unit will switch off and the picture will stop being projected. (The POWER button on the projector will illuminate orange while the cooling fan is still operating.)
NOTE:
BPress any button other than the POWER button to cancel the “POWER OFF” screen.
BThe “POWER OFF” screen will disappear in five seconds.
%Disconnect the mains lead after the POWER button on the projector illuminates red.
NOTE:
BYou can also turn off the power by holding down the POWER button for at least 0.5 seconds.
the power is turned off. |
POWER button on the projector
POWER button status | Projector status | ||
Red | Illuminated | The projector is in standby mode and image projection | |
is possible by pressing the POWER button. | |||
|
| ||
|
|
| |
|
| The projector is preparing for projection after the | |
| Flashing | power has been turned on while the POWER button | |
Green | on the projector is illuminated red. (After a short | ||
| |||
|
| period, a picture will be projected.) | |
| Illuminated | A picture is being projected. | |
|
|
| |
|
| The lamp is cooling down after the power has been | |
| Illuminated | turned off or while direct power off function is | |
|
| operating. | |
Orange |
|
| |
| The projector is preparing for projection after the | ||
| Flashing | power has been turned on while the POWER button | |
| on the projector is illuminated orange. (After a short | ||
|
| ||
|
| period, a picture will be projected.) | |