Do not place any heavy objects on top of the projector.
BFailure to observe this may cause the projector to become unbalanced and fall, which could result in damage or injury.
Do not
BFailure to observe this may cause the batteries to overheat, leak, explode or catch fire, and burns or other injury may result.
When inserting the batteries, make sure the polarities (+ and
BIf the batteries are inserted incorrectly, they may explode or leak, and fire, injury or contamination of the battery compartment and surrounding area may result.
Use only the specified batteries.
BIt is a good idea to clean the inside of the projector before the season for humid weather arrives. Ask your nearest Authorised Service Centre to clean the projector when required. Please discuss with the Authorised Service Centre regarding cleaning costs.
We are constantly making efforts to preserve and maintain a clean environment. Please take non repairable units back to your dealer or a recycling company.
Accessories
Check that all of the accessories shown below have been included with your projector.
Preparation
BIf incorrect batteries are used, they may explode or leak, and fire, injury or contamination of the battery compartment and surrounding area may result.
Insulate the battery using tape or similar before disposal.
BIf the battery comes into contact with metallic objects or other batteries, it may catch fire or explode.
Do not put your weight on this projector.
BYou could fall or the projector could break, and injury may result.
BBe especially careful not to let young children stand or sit on the projector.
If not using the projector for an extended period of time, disconnect the mains plug from the mains socket.
B If dust builds up on the mains plug, the resulting humidity may damage |
the insulation, which could result in fire. |
Card remote control unit (N2QAYC000001 x1)
POWER INPUT | MENU |
ENTER
AUTO
SETUP
STD
SHUTTER
RETURN 
ENTERVOLUME
Lithium battery for | RGB signal cable |
remote control unit | [1.8 m (5´10˝), |
K1HA15DA0002 x1] |
Mains lead | Softcase |
(K2CM3DR00002 x 1) | (TPEP017 x 1) |
B This projector continues to draw approximately 3 W of power even when |
the power is turned off. |
Disconnect the mains plug from the mains socket as a safety precaution before carrying out any cleaning.
BElectric shocks can result if this is not done.
If the lamp has broken, ventilate the room immediately. Do not touch or bring your face close to the broken pieces.
BFailure to observe this may cause the user to absorb the gas which was released when the lamp broke and which contains nearly the same amount of mercury as fluorescent lamps, and the broken pieces may cause injury.
BIf you believe that you have absorbed the gas or that the gas has got into your eyes or mouth, seek medical advice immediately.
BAsk your dealer to replace the lamp unit and check the inside of the projector.
Ask an Authorised Service Centre to clean inside the projector at least once a year.
BIf dust is left to build up inside the projector without being cleaned out, it can result in fire or problems with operation.
ROTATE