Correcting the image position automatically (AUTO SETUP)
This projector can adjust the position of the image and the settings for “DOT CLOCK” and “CLOCK PHASE” when PC signals are being input.
Turning off the picture and sound momentarily (SHUTTER)
The “SHUTTER” function can be used to momentarily turn off the picture and sound from the projector when the projector is not being used for short periods of time, such as during breaks in meetings or when carrying out preparation. The projector uses less power in “SHUTTER” mode than it does
POWER INPUT | MENU |
Press the AUTO SETUP button while PC signals are being projected.
in normal projection mode.
ENTER
AUTO
SETUP
STD
SHUTTER
RETURN 
ENTERVOLUME
Screen
Projected image
POWER INPUT | MENU |
ENTER
AUTO
SETUP
STD
Press the SHUTTER button.
BThe picture and sound will be turned off.
BPress any button on either the projector or remote control unit to return to normal operating mode.
ROTATE
B Automatic positioning | [ | ||
will be carried out. | |||
| |||
|
|
| |
SHUTTER
RETURN 
ENTERVOLUME
ROTATE
Adjusting the volume (VOLUME)
Useful functions
NOTE:
BIf the dot clock frequency is 100 MHz or higher, “DOT CLOCK”, and “CLOCK PHASE” will not be adjusted automatically. Refer to page 48 for details.
BIf the edges of the projected image are indistinct, or if a dark picture is being projected, the automatic setup processing may stop automatically before it is complete. If this happens, project a different picture and then press the AUTO SETUP button again.
|
| Press the VOLUME +/- button. |
POWER INPUT | MENU | B Press the + button to raise the volume. |
|
| B Press the - button to lower the volume. |
| ENTER |
|
AUTO
SETUP
STD
SHUTTER
RETURN 
ENTERVOLUME
ROTATE