Panasonic PT-L795U manual Setting the projector up horizontally, Retracting the adjustable legs

Setting the projector up horizontally

If the projector is not set up so that it is horizontal, it will not be possible to obtain a distortion-free picture. If placing the projector on top of a table or similar surface, carry out the following procedure below to ensure that no distortion of the picture occurs.

Adjustment procedure

1.Lift the front of the projector until the projector as a whole is horizontal. While holding it in this position, press the adjuster buttons under the sides of the projector (1 each at left and right). When the buttons are pressed, the left and right adjustable legs will drop down until they reach the setting-up surface.

NOTE:

Do not release the buttons until both legs have reached the setting-up surface.

Adjuster button

Adjustable legs

Adjuster button

2.Release the adjuster buttons. (The adjustable legs will lock as soon as the buttons are released.)

3.Turn the adjustable legs by hand in either direction

to make fine adjustments to the level of the projector so that the projector is perfectly horizontal.

NOTE:

The legs can be extended by up to (60 mm). If you try to extend them any further than this, they will merely spin freely.

UP to (60 mm)

<Retracting the adjustable legs>

After lifting the front of the projector slightly, press and hold the adjuster buttons and then gently lower the projector.

NOTE:

Be sure to support the projector firmly while pressing the adjuster buttons. If the adjuster buttons are pressed without supporting the projector, the adjustable legs will suddenly unlock and the projector will fall down, which could damage the projector.

Adjuster button

Adjustable legs

Adjuster button

17