Selecting the picture mode

Turning off the sound

If the MUTE button on the remote control unit is pressed, “MUTE” will be displayed on the screen as shown in the illustration below and the sound will be muted. If the MUTE button is pressed once more, the on-screen display will be cleared and the normal sound volume will be restored. The volume output level will remain displayed on the screen for approximately three seconds.

Remote control unit	NOTE:
	If the MUTE button is pressed while the on-screen display
	for another function is currently on the screen, the volume
	will still be muted but the “MUTE” on-screen display will not
	appear.
	If the power supply is turned off or either of the VOL (+/-)
	buttons is pressed, the mute setting will be canceled.
	It is also possible to have the picture turn off together with
	the sound when the MUTE button is pressed. Refer to page
	37 for details on how to change this setting.
	When the picture has been turned off in this way, the words
	“PICTURE MUTE” will be displayed on the screen.

In order to obtain better picture quality, two types of picture mode are available for VIDEO/S-VIDEO signals and RGB signals.

Use the procedure given below to select the desired mode (NATURAL/DYNAMIC).

Setting procedure

1.Press the MENU button. The MENU screen will be displayed.

2.Use the “ ” and “ ” arrow buttons to move the cursor to “PICTURE”.

3.Press the ENTER button. The PICTURE screen will be displayed.

4.Use the “ ” and “ ” arrow buttons to move the cursor to “PICTURE MODE”.

5.Use the " ” and “ ” arrow buttons to switch the setting to “NATURAL” or “DYNAMIC” until the best picture is obtained.

NATURAL: The picture obtained is appropriate when using this projector in places with standard brightness.

DYNAMIC: The picture obtained is appropriate when using this projector in brighter places.

NOTE:

Once a picture mode is selected by the above procedure, the picture can then be adjusted further as desired. Refer to the following page for details on adjustment methods.

If the MENU button is pressed, the display will return to the MENU screen, or the MENU screen will be cleared if it is already being displayed.

If the STD button is pressed while the PICTURE screen is being displayed, “STD” will be displayed in the top- right corner of the screen and the adjustment value being displayed (except for TV-SYSTEM) will be returned to the factory default setting in accordance with the picture mode selected.