Fujitsu warranty Storing the Stylistic LT800P Tablet, Avoiding Overheating

Page 48

S t y l i s t i c L T 8 0 0 P T a b l e t

4.Apply pressure to the screen protector with your finger using a continuous wiping motion along the edges. The adhesive sets completely within 48 hours. To ensure a good seal between the screen protector and the display, do not lift the screen protector from the display once it has been applied.

5.Remove the protective plastic cover from the face of the screen protector.

6.Clean any residue left behind by the protective coating from the exposed surface of the screen protector by wiping gently with a soft cotton cloth dampened with denatured alcohol. Wipe the screen protector with a soft dry cloth to remove any low-tack adhesive; this will help prevent the pen tip from squeaking.

Storing the Stylistic LT800P Tablet

Be sure not to store your Stylistic LT800P with the screen side down, otherwise damage to the display may occur.

Store your tablet in the Off state with a fully charged battery pack installed. The battery pack always provides power to some system components, even when the system is in Off state. If the system is stored with the battery pack removed, these components are powered by the system’s internal bridge battery. The bridge battery is not designed for extended use and will discharge in a short period of time; this could result in damage to the batteries. You can store the tablet in the Off state for about 30 days with a fully charged battery pack installed. After this period, the battery pack should be recharged or replaced with a charged battery pack.

Avoiding Overheating

The Stylistic LT800P tablet monitors its internal temperature. As the internal temperature approaches the tolerable limits of heat-sensitive components, system functions are automatically limited or turned off to prevent damage.

To avoid overheating the tablet, do not obstruct the air vents on the top and bottom edges of the tablet.

46

Image 48

Contents

According to FCC Part Y l i s t i c L T 8 0 0 P T a b l e t Table of Contents Care and Maintenance Preface Y l i s t i c L T 8 0 0 P T a b l e t About This Guide Conventions Used in the GuideLimited Warranty Information Service and SupportFujitsu Contact Information Fujitsu OnlineGetting Started Y l i s t i c L T 8 0 0 P T a b l e t Getting to Know Your Tablet In-box ItemsOptional Accessories Peripheral/Accessory Fujitsu Part NumberStylistic LT800P Tablet Features Stylistic LT800P Tablet Features Front ViewFront / Top / Left Features Stylistic LT800P Tablet Features Rear View Rear / Bottom / Right Features Status Display Status Display IconsSystem Status Indicators Mode/State LED State RemarksBattery RAMHovering Connectors and Peripheral Interfaces Left-Side Connectors and InterfacesPeripheral Connectors/Interfaces ConnectorPurpose PeripheralCommunication is about 3 feet, and within Additional System Icons Using the Stylistic LT800P Tablet Y l i s t i c L T 8 0 0 P T a b l e t Using Your Stylistic LT800P System StatesPower Icon Current State To Change State Appearance Changing System StatesPowering Up the Tablet Shutting Down the SystemSuspending System Operation Power icon is blinking Suspend-to-RAMmode Down the system rather than using Suspend-to-RAM mode Resuming System Operation Using Hotpads Stylistic Hotpad ArraysHotpad Keys IconIcon Name Description Using the Pen Calibrating the penTo Calibrate the Pen Using Hovering Mode Charging the Battery PackReplacing the Pen Removing and Installing the Battery Pack Battery Pack Charging Time90% 100%Removing the Battery Pack Tips for Conserving Battery Power Operation of the Bridge BatteryChanging the Bios Settings Modem ConnectionPC Card Slot LAN Port RJ-45Starting Bios Setup Y l i s t i c L T 8 0 0 P T a b l e t Care and Maintenance Y l i s t i c L T 8 0 0 P T a b l e t Caring for Your Stylistic LT800P Protecting the Display ScreenStoring the Stylistic LT800P Tablet Avoiding OverheatingTroubleshooting Y l i s t i c L T 8 0 0 P T a b l e t System Will Not Resume Operation Display Screen Is Blank or Difficult to ReadInfrared Data Transfer Is Not Working Audio Volume Too Low Configuring Peripherals InterfacesCursor Is Not Tracking Pen Tablet Is Not Responding to the PenHardware Specifications Y l i s t i c L T 8 0 0 P T a b l e t Stylistic LT800P Hardware Specifications Stylistic LT800P Tablet SpecificationsInterface Specifications Stylistic LT800P Tablet Specifications Power Specifications Environmental SpecificationsAgency Approval Specifications Additional SpecificationsY l i s t i c L T 8 0 0 P T a b l e t Agency Notices Y l i s t i c L T 8 0 0 P T a b l e t Agency Notices Y l i s t i c L T 8 0 0 P T a b l e t DOC Industry Canada Notices Y l i s t i c L T 8 0 0 P T a b l e t UL Notice Y l i s t i c L T 8 0 0 P T a b l e t Appendix Y l i s t i c L T 8 0 0 P T a b l e t Wireless LAN, Health and Authorization for use FCC Regulatory InformationRegulatory Notes and Statements Regulatory Information/DisclaimersFCC Interference Statement FCC Radio Frequency Exposure statementExport restrictions Before Using This Device Characteristics of the DeviceWireless LAN Modes Using this Device AdHoc ModeHow to Handle This Device Infrastructure ModeConnecting Windows 2000 Systems Setting ParametersWorkflow Table A-1 Profile Parameters DescriptionTable A-2 Encryption Key Setup WEPNetwork Settings TCP/IP SettingsNetwork Connection Windows Table A-3 Setting an IP Address Checking the full computer name and workgroupSetting File and Printer Sharing for Microsoft Networks SharingTable A-4 Checking computer name and workgroup Sharing Files Table A-5 Sharing files Printer SharingTable A-6 Printer Sharing Accessing Another Computer Checking the ConnectionChecking the Connectivity Table A-7 Checking connectivityConnecting Windows XP Systems Table A-8 Setting parameters Network Settings Table A-9 Setting an IP addressNetwork Connection Table A-10 Setting computer name and workgroup SharingSetting File and Printer Sharing for Microsoft Networks Checking the Connection Table A-11 Checking connectivity Troubleshooting Troubleshooting TableProblem Possible Cause Possible Solution Signal Retry the connection Where directory and filename repre If the connection is successful Problem Possible Solution WindowsWindows XP Setting IP Addresses About IP AddressesSpecifications Technical Specifications for Integrated Wireless LAN DeviceY l i s t i c L T 8 0 0 P T a b l e t Index Y l i s t i c L T 8 0 0 P T a b l e t Items included with, 9 Stylistic LT P-867 Specifications Y l i s t i c L T 8 0 0 P T a b l e t 100