U s i n g t h e W i r e l e s s L A N
Checking the Connectivity
1.Click [Start]
2.
3.Check the connectivity on the [Link] tab. The current condition of connection is displayed.
Item | Description | |
|
| |
| Shows the current condition of connection. | |
State | The MAC address of the other computer that you are connected | |
to is displayed, when the connection is successfully made. If you | ||
| are connected to more than one computer, the computer that has | |
| the best connectivity is displayed. | |
|
| |
Current Channel | Shows the current channel used for the connection. | |
|
| |
Current Tx Rate | Shows the current transfer rate in Mbits/sec. | |
|
| |
Radio Off/Radio | Click [Radio OFF] to disconnect. | |
On | Click [Radio On] to connect to the network. | |
|
| |
Rescan | Click this button to search for others to connect to. | |
|
| |
Throughput | Shows the actual transfer rate of the transfer data for send (Tx) | |
(Bytes/sec) | and receive (Rx). | |
|
| |
Link Quality | Shows the link quality. This is not shown for the AdHoc connec- | |
tion. | ||
| ||
|
| |
Signal Strength | Shows the signal strength. | |
This is not shown for the AdHoc connection. | ||
| ||
|
| |
| Table |
87