Fujitsu LT800P warranty Where directory and filename repre

Problem

Possible Cause

Possible Solution

IP packet isn’t

Run the PING

Perform the following steps to run the

reaching its

command to check

PING command to check if the IP packet is

destination

the connection

correctly delivered to the destination.

To run the PING command, the TCP/IP

protocol must be installed. First you will

determine your IP address, then you will

make sure your IP address can respond,

and then you will make sure other

computers can be addressed.

1. Windows 2000:

Click [Start] -> [Programs] -> [Acces-

sories] -> [Command Prompt].

Windows XP:

Click [Start] -> [All Programs] ->

[Accessories] -> [Command Prompt].

2. Type: ipconfig > directory\filename

where directory and filename repre-

sent the location at which you want to

store the IP address.

3. Click [Enter], then go to the location

you specified above. The IP address

for your system will be contained in

the file.

4. To check that your IP address is func-

tioning properly, go back to the DOS

prompt and type: ping <IP address>,

then press [Enter]. You will receive

several replies, followed by the PING

statistics (similar to below).

5. To check that your system is communi-

cating with other systems, go to the

DOS prompt and type:

\>ping XXX.XXX.XXX.XXX. (With the

destination IP address in place of

XXX.XXX.XXX.XXX).

(continued on next page)