Zebra Technologies 2824-Z manual What’s in the Box?

Page 12

Introduction

What’s in the Box?

What’s in the Box?

Save the carton and all packing materials in case you need to ship or store the printer later. After unpacking, make sure you have all parts. Follow the procedures for inspecting the printer to familiarize yourself with printer parts so you can follow the instructions in this book.

Sample

Labels

Documentation

and Warranty

Cleaning

Printer

PenPower Supply and Cords

12

LP 2824-Z User Guide

980531-001 A

Image 12

Contents User Guide Customer Order # 980531-001 a Proprietary Statement Product ImprovementsFCC Compliance Statement Canadian DOC Compliance Statement Liability DisclaimerLimitation of Liability Preface ContactsEnvironmental Management Document ConventionsSupport Related Documents Preface Contents Operations & Options Introduction HelloWhat’s in the Box? Inspecting the Printer Opening the printerAfter opening the printer, check the media compartment Closing the printer Reporting DamageIntroduction Getting Started Modes of PrintingAttaching Power Supply Adjusting the Roll Holders Loading Roll MediaPlacing the Roll in the Media Compartment Adjusting the Guides Power Switch Operator ControlsFeed Button Status LightPrinting a Test Label Hooking Up the Printer and Computer Interface Cable RequirementsCommunicating with the Printer Ethernet Interface RequirementsAdjusting the Print Width Adjusting the Print QualityOperations & Options Thermal Printing Replacing Supplies Printing in Peel-Mode XA MMP XZ XA JUS XZOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Maintenance CleaningPrint Head Considerations Media Path Considerations Sensors Lubrication Platen ConsiderationsReplacing the Platen RemovalReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Troubleshooting ResolutionsPrinter is not receiving power Printer is on and in an idle statePrinter has failed its power on self test Post There is a shortage of memoryPrinter is receiving data Either the media or ribbon is outPrint head is under temperature Print head is over temperatureFlash memory is not programmed Print Quality Problems Ribbon sensor settings did not printNo print on the label Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Troubleshooting Tests Printing a Configuration LabelRecalibration Resetting the Factory Default Values Communications DiagnosticsPower Off Mode Communications Diagnostics Mode Feed Button ModesBattery Universal Serial Bus USB Connector InterfacesParallel Interface 33-34ZebraNet PrintServer II for Ethernet Networks Rx+Serial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp