Zebra Technologies 2824-Z manual Printing in Peel-Mode, Xa Mmp Xz Xa Jus Xz

Page 30

Operations & Options

Printing in Peel-Mode

Printing in Peel-Mode

The optional dispenser allows you to print in “peel-mode” where the label backing follows a different path and the labels are presented one at a time for subsequent placement.

Before using peel-mode, you must send the programming commands to the printer.

^XA ^MMP ^XZ ^XA ^JUS ^XZ

Refer to your ZPL II Programmer’s Manual.

1.Remove several labels from the backing material.

2.Open the top cover.

3.Open the dispenser door.

4.Using a stylus, switch on the label-taken sensor.

5.Insert the backing in front of the peel bar and behind the peel roller.

6.Close the dispenser door.

7.Close the top cover.

8.Press the Feed button to advance the label.

9.During the print job, the printer will peel off the backing and present a single label. Take the label from the printer so it will print the next label.

30

LP 2824-Z User Guide

980531-001 A

Image 30

Contents User Guide Customer Order # 980531-001 a Proprietary Statement Product ImprovementsFCC Compliance Statement Canadian DOC Compliance Statement Liability DisclaimerLimitation of Liability Preface ContactsEnvironmental Management Document ConventionsSupport Related Documents Preface Contents Operations & Options Introduction HelloWhat’s in the Box? Inspecting the Printer Opening the printerAfter opening the printer, check the media compartment Closing the printer Reporting DamageIntroduction Getting Started Modes of PrintingAttaching Power Supply Adjusting the Roll Holders Loading Roll MediaPlacing the Roll in the Media Compartment Adjusting the Guides Feed Button Power SwitchOperator Controls Status LightPrinting a Test Label Hooking Up the Printer and Computer Interface Cable RequirementsCommunicating with the Printer Ethernet Interface RequirementsAdjusting the Print Width Adjusting the Print QualityOperations & Options Thermal Printing Replacing Supplies Printing in Peel-Mode XA MMP XZ XA JUS XZOperations & Options Printing on Fan-Fold Media Using the Cutter Option Operations & Options Maintenance CleaningPrint Head Considerations Media Path Considerations Sensors Lubrication Platen ConsiderationsReplacing the Platen RemovalReplacing the Print Head Thermal-Transfer LP Model Replacing the LP Print Head Maintenance Printer is not receiving power TroubleshootingResolutions Printer is on and in an idle statePrinter is receiving data Printer has failed its power on self test PostThere is a shortage of memory Either the media or ribbon is outPrint head is under temperature Print head is over temperatureFlash memory is not programmed No print on the label Print Quality ProblemsRibbon sensor settings did not print Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Troubleshooting Tests Printing a Configuration LabelRecalibration Resetting the Factory Default Values Communications DiagnosticsPower Off Mode Communications Diagnostics Mode Feed Button ModesBattery Universal Serial Bus USB Connector InterfacesParallel Interface 33-34ZebraNet PrintServer II for Ethernet Networks Rx+Serial RS-232 Connector Connecting the Printer to a DTE Device Interfaces Page Customer Order # 980531-001A 2004 ZIH Corp